BP-25H CE GASOLINEVIBRATOR — ENGINE COMPONENTS
INITIAL SERVICING
The engine (Figure 4) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturer’s engine manual for instructions and details of operation and servicing.
1. Choke Lever – Used in the starting of a cold engine, or in cold weather conditions. The choke enriches the fuel mixture.
2. Spark Plug – Provides spark to the ignition system. Clean spark plug once a week.
3. Recoil Starter (pull rope) –
4. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).
5.Oil Drain Plug – Remove this plug to remove oil from the engine's crankcase.
6.Dipstick/Oil Filler Cap – Remove this cap to determine if the engine oil is low. Add oil through this filler port as recommended in Table 3.
7. Air Filter – Prevents dirt and other debris from entering the fuel system. Press the latch tabs on the top of the air cleaner cover, and remove cover to gain access to filter element.
Operating the engine without an air filter, with a damaged air filter, or a
NOTE filter in need of replacement, will allow dirt to enter the engine causing rapid engine wear.
Figure 4. Honda GXH50 Engine Components
8. Fuel Tank/Fuel Filler Cap – Fuel tanks holds 0.32 gallons (1.2 liters) of unleaded gasoline. Remove fuel filler cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.
DANGER - EXPLOSIVE FUEL HAZARD
Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill DO NOT attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.
9. Muffler – Used to reduce noise and emissions.
DANGER - BURN HAZARD
Engine components can generate extreme heat.To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.
10. Engine ON/OFF Switch – ON position permits engine starting, OFF position stops engine operation.
11.Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop the flow of fuel.