Multiquip manual BP-25H CE GAS Vibrator Preparation for Long -TERM Storage

BP-25H CE GAS VIBRATOR — PREPARATION FOR LONG -TERM STORAGE

For storage of the vibrator for over 30 days, the following is required:

■Drain the fuel tank completely, or add STA-BIL to the fuel.

■Run the engine until the gasoline in the carburetor is completely consumed.

■Completely drain the oil from the crankcase and refill with fresh oil.

■Remove the spark plug, pour 2 or 3 cc of SAE 30 oil into the cylinder and crank slowly to distribute the oil.

■Slowly rotate the engine a few times with the starter rope and install a new plug.

■Pull out the starter rope slowly and stop at the compression point.

■Clean all external parts of the engine and frame with a soft cloth.

■Cover the unit and store in a clean, dry place.

Decommissioning Vibrator/Components Decommissioning is a controlled process used to safely retire a piece of equipment that is no longer serviceable. If the equipment poses an unacceptable and unrepairable safety risk due to wear or damage or is no longer cost effective to maintain (beyond life-cycle reliability), and is to be decommissioned (demolition and dismantlement), the following procedure must take place:

■Drain all fluids completely. These may include oil, gasoline, hydraulic oil and antifreeze. Dispose of properly in accordance with local and governmental regulations. Never pour on ground or dump down drains or sewers.

■Drain excess gasoline from the fuel system into an approved storage container.

■Engine block is made of recyclable aluminum. Plastic engine components should be removed and recycled separately.

■The frame and control arm are manufactured of recyclable steel. Bring to a salvage yard or metal reclamation facility for further dismantling.

■The harness assembly is made of non-recyclable fabric.

BP-25H CE GASOLINE VIBRATOR — OPERATION MANUAL— REV. #4 (12/19/07) — PAGE 25