BP-25H CE GASOLINEVIBRATOR — PROTECTIVE SLEEVE INSTALLATION
Casing Coupling Protective Sleeve
When rubber vibrator heads are used, it is advisable to place a protective sleeve over the flexible shaft casing coupler. This will protect epoxy coated rebar from being damaged. Please follow the instructions listed below to install the protective sleeve. Reference Figure 8 when performing the installation of the protective sleeve.
n Slide the casing cover protective sleeve onto and the |
| It will take approximately one hour |
flexible shaft (vibrator end). |
| |
o Using a open end wrench and locking type pliers, attach | NOTE | for the sealant to set (cure) so that |
| the protective sleeve will stay in | |
vibrator head to flexible shaft. It is recommended to |
| place during operation. |
apply a small amount of pipe thread sealant on the casing |
| |
|
| |
coupler threads to prevent water from entering the |
|
|
vibrator head. |
|
|
pApply a uniform 3/8” bead of adhesive about
qPush casing coupling protective sleeve over flexible shaft coupling, rotating sleeve as you push, until end of sleeve enters recess on vibrator head.
rMake sure to place a bead of adhesive at the opposite end of the sleeve to prevent wet concrete from entering the opening.
Figure 8. Casing Coupling Protective Sleeve
Installation
PAGE 18 —