Multiquip manual BP-25H CE Gasolinevibrator Initial START-UP Engine

BP-25H CE GASOLINEVIBRATOR — INITIAL START-UP (ENGINE)

This section is intended to assist the operator with the initial start-upof the BP-25H CE vibrator. It is extremely important that this section be read carefully before attempting to use the vibrator in the field.

Starting the Engine

1.Place the engine fuel valve lever (Figure 9) to the "ON" position.

4.Place the Ignition ON/OFF switch (Figure 12) in the "ON "position.

Figure 12. Ignition ON/OFF Switch (ON Position)

CCW ROTATION

DECREASES

ENGINE SPEED

(IDLE)

6. Turn the throttle grip CCW to the “TURTTLE” position (Figure 13) to start the en- gine in the idle mode.

THROTTLE

GRIP

Figure 9. Engine Fuel Valve Lever (ON Position)

2.Placethechokelever(Figure10)inthe"CLOSED"position if starting a cold engine.

Figure 10. Engine Choke Lever (Closed)

Figure 13.Throttle Grip (Idle/Turttle Position)

7.Grasp the starter grip (Figure 14) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingtothecompressionpoint.Pullthestartergripbriskly and smoothly for starting.

3.Place the choke lever (Figure 11) in the "OPEN " position if starting a warm engine or the temperature is warm.

Figure 14. Starter Grip

8.If the engine has started, slowly return the choke lever (Figure15)totheOPEN position.Iftheenginehasnotstarted repeat steps 1 through 6.

Figure 11. Engine Choke Lever (Open)

Figure 15. Choke Lever (Open)

BP-25H CE GASOLINE VIBRATOR — OPERATION MANUAL— REV. #4 (12/19/07) — PAGE 19