Ikelite 6871.07 instruction manual Attaching an Ikelite Strobe Arm to the Housing Handle

Page 21

Attaching an Ikelite Strobe Arm to the Housing Handle

To attach an Ikelite Arm to your Housing Handle, depress the spring-loaded Handle Push Button until it stops. Gently slide the pronged end of the Ikelite Arm into the hole in the top of the Handle as shown.

When the Ikelite Arm is properly seated, the Handle Push Button will return to its starting position.

Ikelite Arm

Housing Handle

Handle Push

Button

Image 21

Contents Canon EOS 7D SLR-DC HousingTable of Contents Specifications Preparation Package ContentsSide View Parts of the Housing Front ViewBack View Opening the Housing Initial Camera SetupSetting the Conversion Circuitry Strobe ID Switch Housing Conversion CircuitryMode and Compensation Buttons Using the Conversion Circuitry Set DS Substrobe to TTL modeAttaching the Flash Connection for External Strobes DS50 and DS125 Substrobe CompatibilityInstalling Camera in Housing Attaching Camera to Housing TrayFinal Check Closing the HousingTurn Camera On Attaching a Sync Cord to the HousingZoom Clamps & Gear Sleeves Included with Housing Preparing to Install Zoom Clamp & Gear SleeveInstalling the Zoom Clamp & Gear Sleeve On the Type 1 Lenses Figure D Type 1 LensesInstalling the Zoom Clamp & Gear Sleeve On Type 2 Lenses Manual Focusing Installing Zoom Clamp/Sleeve on Type 2 LensesInstalling the Port Installing the Port To Remove Port Port Seal Inside ViewLens Ports Attaching an Ikelite Strobe Arm to the Housing Handle Usage Pre-Dive Your SystemLubricants Problem Solution TroubleshootingAny trapped moisture forming fog on the lens port Recommended Accessories Accessory Mounting PointsEV-Controller Use Control Maintenance MaintenanceDiagram B Housing Maintenance Storing the Housing Spare PartsPhoto Tips Photo Tips Technical SupportLimited Warranty Returning Products For ServiceReturning Products for Service outside the United States Product Registration