Ikelite 6871.07 instruction manual Package Contents, Preparation

Page 4

Package Contents

-

SLR-DC Housing

- Aluminum Tray & Dual Handles

-

Envelope containing tray

-

Silicone Lubricant

 

installation hardware,

-

Standard Zoom Clamp & Sleeve Set

 

maintenance kit, and extra

-

#5509.28 Large Diameter Zoom

 

control end tips.

 

Clamp & Sleeve Set

Preparation

This product has been water pressure tested at the factory and is depth rated to 200 ft. (60m). Thoroughly inspect and immerse the empty housing completely in water before installing a camera. If any fogging occurs or droplets of water enter the housing, do not install a camera. Clean the housing main o-ring and retest to make sure that it is watertight. Refer to the Troubleshooting section, page 23.

We suggest that you read this instruction booklet thoroughly before use to have a full understanding of where each camera control is located, and what function each control provides. Please read your camera manual thoroughly to have a full understanding of each camera function. If you are new to underwater photography, be sure to read the Photo Tips section.

Due to the power required to operate the camera and LCD screen start each dive with a fully charged camera battery.

Attach External “Tray with Handles” to Housing

Use hardware and instructions located in the clear Ikelite pouch to attach the “Tray with Handles” to your Ikelite housing.

IKELITE

Port Lock

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents SLR-DC Housing Canon EOS 7DTable of Contents Specifications Package Contents PreparationParts of the Housing Front View Side ViewBack View Initial Camera Setup Opening the HousingHousing Conversion Circuitry Setting the Conversion Circuitry Strobe ID SwitchUsing the Conversion Circuitry Set DS Substrobe to TTL mode Mode and Compensation ButtonsDS50 and DS125 Substrobe Compatibility Attaching the Flash Connection for External StrobesAttaching Camera to Housing Tray Installing Camera in HousingClosing the Housing Final CheckAttaching a Sync Cord to the Housing Turn Camera OnPreparing to Install Zoom Clamp & Gear Sleeve Zoom Clamps & Gear Sleeves Included with HousingInstalling the Zoom Clamp & Gear Sleeve On the Type 1 Lenses Type 1 Lenses Figure DInstalling the Zoom Clamp & Gear Sleeve On Type 2 Lenses Installing Zoom Clamp/Sleeve on Type 2 Lenses Manual FocusingInstalling the Port Port Seal Inside View Installing the Port To Remove PortLens Ports Attaching an Ikelite Strobe Arm to the Housing Handle Pre-Dive Your System UsageLubricants Troubleshooting Problem SolutionAny trapped moisture forming fog on the lens port Accessory Mounting Points Recommended AccessoriesEV-Controller Use Maintenance Control MaintenanceDiagram B Housing Maintenance Spare Parts Storing the HousingPhoto Tips Technical Support Photo TipsReturning Products For Service Limited WarrantyReturning Products for Service outside the United States Product Registration
Top Page Image Contents