b. Slide knurled knob on Control Handle up to threaded section on Camera cable and finger tighten to secure Camera cable in place.
3.To attach Hook (4), Magnet (5), or Mirror (6) to Camera (2), open hinged sleeve on accessory and clip in place over indented section near camera.
4.The Monitor can be used while at- tached to the Control Handle or unat- tached, in close proximity.
5.To attach Monitor (3) to Control Handle (1):
a.Carefully align flanges on back of
Control Handle with section on back of Monitor.
b.When the flanges are carefully aligned, slide Monitor downward to lock it in place on the Control Han- dle.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.When recharging the Monitor, keep the Monitor close to the Adaptor so that the cord does not present a trip- ping hazard.
General Operating Instructions
Only the 3 ft. Camera cable is
water resistant, and ONLY when the unit if fully assembled. DO NOT immerse Control Handle or Monitor. DO NOT use if condensation forms on lens. Let water evaporate before using.
Note: The Monitor needs to be charged before using on the Control Handle. However, it can function while unit is charging.
1.Assemble components as shown in Set Up section, using desired acces- sory attachment as needed.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
ON/OFF Dial
2.Turn ON/OFF dial on Control Handle
(1) backwards to turn on power to camera. Two LEDs near Camera and
SKU 66550 | For technical questions, please call | Page 7 |