Specifications
CAMERA |
|
| |
|
|
| |
Total Pixels | 704x576 | (PAL); | |
712x486 | (NTSC) | ||
| |||
Modulation Type | FM |
| |
|
|
| |
Bandwidth | 18MHz |
| |
Power Supply | 4 AA batteries | ||
MONITOR |
|
| |
|
| ||
LCD Screen Type | |||
Effective Pixels | 480x240 |
| |
Electrical Input | |||
Adapter Input | 120 V~ / 60 Hz | ||
Operating Temperature | +14°F~+122°F | ||
Operating Humidity | 15~85%RH | ||
including HVAC inspection, automotive/ boat/aircraft inspection, cable routing, etc.
To prevent injury from
accidental operation: Turn the Power Switch on the Control Handle and Monitor to “OFF” position and unplug the Adaptor from its electrical outlet before performing any adjustments, inspection, maintenance, or cleaning procedures.
Note: For additional information regarding the parts listed in the following pages, refer to the Parts Diagram near the end of this manual.
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Instructions for putting into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Functions
This mini water resistant camera with 3 ft. flexible tubing can be used to view hard to reach locations while displaying
Inspection Camera Set Up
1.To install Batteries:
a.Remove screw and cover on bottom of Control Handle (1).
b.Slide Battery Compartment out of Control Handle (1) and insert four AA batteries.
c.Reinstall battery compartment and cover. Secure with screw.
Keyed ends | Control |
| |
| Handle |
Camera
Knurled Knob 
2.To attach Camera (2) to Control Handle (1):
a.Align keyed ends of Control Handle with cable end of Camera.
SKU 66550 | For technical questions, please call | Page 6 |