Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent injury from
accidental operation: Turn the Power Switch of the Monitor to its “OFF” position and unplug the adaptor from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
To prevent injury from tool failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wir- ing, and any other condition that may affect its safe operation.
2.After Use, clean external surfaces of the tool with clean cloth.
3.
WARNING! If the supply cord of the adaptor is damaged, it must be replaced only by a qualified ser- vice technician.
Charging Monitor
Adapter Cable (7)
Adapter (8) | Monitor (3) |
1.Plug male end of Adapter Cable (7) into Monitor (3) and female end onto Adapter (8) plug. Plug adapter (8) into wall socket.
2.Power light will be red, indicating unit is charging. With the monitor at- tached to the control handle, unit can still be used while monitor is charg- ing, but only when attached to the handle.
3.When unit is fully charged, red light will turn off.
4.Fully charged monitor will work con- tinuously for approximately 5 hours.
REV 09f
SKU 66550 | For technical questions, please call | Page 9 |