Ventilaiion | Samsung HMX-Q10PN/HMX-Q100PNIHMX-Q130PN specs

14Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as powersupply cord or plug is damaged, liquid has been spilled or objects have falbn into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed ors the apparatus.

16.VENTILAIION:

Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the CAMCORDER and to protect

it from overheating. These openings must not be blocked or covered. Never place your CAMCORDER orsa bed, sofa, rug, or other similar surface: orsor near a radiator or heat register. This CAMCORDER should not be placed in a built-in installation such as a bookcase or rack unbss proper ventilation is provided or the manufacturer's instructions haw_ been adhered to.

17.POWER SOURCES:

The CAMCORDER should be operated only from the type of power source indicated on the label. If you are not sure of the type of power supply at your home, consult your appliance dealer or local power corrlpany. A CAMCORDER is intended to be operated from battery power, or other sources, refer to the operating instructions.

18.GROUNDING OR POLARIZATION:

This CAMCORDER may be equipped with either a polarized 2--wire AC line plug (a plug having one blade wider than the other) or a 3--wire grounding type plug, a plug having a third (grounding) pin. Ifyou are unabb to insert the plug fully into the

Impo_¢ant safety instR,sctions

outlet, try reversing the plug. If the plug still fails to fit, contact your electrician to replace your outlet. Do not defeat the salety purpose of the polarized plug.

19.POWER-CORD PROTECTION:

Power--supply cords should be routed se that they are not likely to be walked orsor pinched by items placed upors or against them, paying particular attention to cords or plugs, convenient receptacles, and the point where they exit from the unit.

20.OUTDOOR ANTENNA GROUNDING:

CAMCORDER, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built- up static charges, Section 810 of the National Electrical Code, ANSI/NFPA No. 70--1984, provides information with respect

to proper grounding of the mast and supporting structure, grounding of the bad-in wire and supporting structure, grounding of the mast and supporting sIructure, grounding of the lead-in wire to an antenna discharge unit, size of grounding to conductors, location of antenna-discharge unit, connection

to grounding electrodes and requirements for the grounding electrode. See figure below.