Samsung SNH-1011ND Connecting via network cable, Internet Service, Router. may take up to 30sec

Network Connection and Settings

Precautions

•The wireless network access may fail, depending on the communications environment.

•For details about the network settings and password, contact your network administrator or service provider.

•For a specific Internet service requiring user authentication, you may not access the service. If this is the case, contact the service provider.

•Do not access the unauthorized network.

•The farther the distance from the Wireless Access Point, the longer time the network connection may take.

•If you fail to access the selected wireless network, try a different Wireless Access Point to make access.

•For more information about the router or the wireless connection, refer to the documentation of the router or contact the router manufacturer.

•If the camera is connected to a multiple-Wireless Access Point network environment, some video packets may be lost, depending on the network traffic load.

•According to the network policy (blocking UDP) of the service provider, the video transmission can be limited to 7 minutes.

•In addition to the above two situations, you may encounter a network delay or interruption due to the network conditions.

•This product has gone through the compatibility test with worldwide top ranking routers in the market but you may still have a problem in compatibility with some conventional routers or other routers manufactured by other than the industry leading companies.

Connecting via network cable

If you do not have a Wireless Access Point, you must connect the camera using LAN cable directly to your home router.

1.When you apply the power, the power status LED is lit red, and it will change to red blinking when the booting is completed.

2.Connect the network cable to the camera and to the home router as shown

below. 02

<Hub>

	<Modem>	Installation
OR	Internet Service

3.	The status LED will become steady blue once the camera is connected to
	the router. (may take up to 30sec).		&
	If the status LED (blue) is not lit, repeat steps 2 through the end and check it
	again.
4.	The status LED will became steady green once the camera is connected to
	server.		Network
n		` It is recommended to set the router to DHCP(Dynamic Host Configuration Protocol)
		server.
		If you want to use static IP address, please refer to <Wired Network> on page 24.
		` If the router’s UPnP is not set, then you might be connected in relay mode.
		The settings may differ depending on the connected Broadband Router model.	Connection
		For more information, refer to the user manual of the applicable router.
		13