Samsung SNH-1011N Connecting via Wi-Fi without WPS feature, Conneting using Wi-Fi WPS feature

Connecting via Wi-Fi without WPS feature

If you want to connect the camera using a non-WPS Wireless Access Point, change the network setting to Wire and try the wireless network.

1.When you apply the power, the power status LED is lit red, and it will change to red blinking when the booting is completed.

2.Use the network cable (LAN cable) to connect the LAN port of the unit to the LAN port of the Wireless Access Point.

Conneting using Wi-Fi WPS feature

What is WPS?

WPS enables to make connection between the camera and the Wireless Access Point with a simple click of the button.

1.When you apply the power, the power status LED is lit red, and it will change to red blinking when the booting is completed.

2.Press the WPS button on the camera for 1sec.

Press the WPS button on the Wireless Access Point within 2min.

<Wireless Access Point>

Internet Service

<Modem>

3.	Register and select the camera according to guide of 03. Monitoring.
4.	Set your wireless network environment using the guideline <Wireless
	Network> on page 25.

WPS Button

DC IN 5V

RESET

NETWORK

SAMSUNG SMARTCAM

RESET

Wi-Fi

Indicator LED

Internet Service

WPS Button

<Wireless Access Point>

<Modem>

n` When the wireless network settings are completed, remove the LAN cable.

` If you fail to connect to the Internet service, contact the service provider for details.

3.The Wi-Fi status LED will become steady blue once the camera is connected to the Wireless Access Point. (may take up to 30sec).

If the Wi-Fi status LED (blue) is not lit, repeat steps 2 through the end and check it again.

4.The Wi-Fi status LED will became steady green once the camera is connected to server.

14 · English