Samsung SHC-730N/P instruction manual Backlight, White Balance Control

Page 14

Operating Your Camera

Backlight

SV-III DSP chip built-in provides intelligent light level control to overcome the severe Backlight conditions.

1.Press the SET button to display the setup menu and move the arrow indicator to ‘Backlight’ using the UP or DOWN button.

 

 

SETUP

CAMERA

ID

OFF

BACKLIGHT

WDR

WHITE

BAL.

ATW

2.SET ‘Backlight’ to the desired mode using the LEFT or RIGHT button.

WDR: In case that bright and dark parts exist on the screen at the same time, your camera allows you to see both parts clearly

OFF: Deactivation

WDR

OFF

3.Press the ‘SET’ button.

• When ‘WDR’ is chosen, you can adjust the LIMIT.

WDR SETUP

WDR LIMIT

LOW

Press SET to Return

You can select the level(LOW,MIDDLE,HIGH).

WDR sensitivity is increased or decreased.

4. When completed, press the SET button.

Notes

If you select manual in ‘shutter’ menu, you can’t use WDR mode.

If you select WDR mode, the following phenomenon may appear by lighting condition. In these cases do not select WDR mode.

Unnatural color change or unnatural phenomenon on the screen

Noise of bright part on the screen

According to the area of bright part on the screen there may be the difference of WDR performance so be sure to adjust the degrees of the visual angle when installing your camera.

If you change WDR LIMIT, unnatural phenomenon may appear.

For the optimal WDR performance, in case of observing the object that is in the place of the changing illumination, recommend to use Auto Iris Lens(Video or DC type, not manual)

White Balance Control

Your camera provides 3 ‘White Bal.’ control modes. You can select the most suitable one. You can adjust the white balance.

1.Press the SET button to display the setup menu and move the arrow indicator to 'White Balance' using the UP or DOWN button.

2.Set ‘White Bal.’ to the desired mode using LEFT or RIGHT button.

 

 

SETUP

CAMERA

ID

OFF

BACKLIGHT

WDR

WHITE

BAL.

ATW

MOTION

DET.

OFF

LENS

 

DC

The four white balance control modes are as follows :

ATW(Auto Tracking White Balance): When color temperature is 1800 ~

10500K, select this mode.

COLOR CCD CAMERA 26 User’s Manual

COLOR CCD CAMERA 27 User’s Manual

Image 14
Contents SHC-730N/P Page Day & Night Stop using your camera when you find a malfunctionHigh Resolution Camera needs periodic inspectionContents Camera PrecautionsOr spill beverage on it Radioactivity Composition Tripod Mounting Bracket Screw HoleMenu Setup Buttons Auto Iris Lens ConnectorDC/VIDEO Selection Switch Name and Function of Each SectionInstalling Auto Iris Lens ConnectionVideo type DC type Installing C/CS-Mount lensMounting a CS-Mount lens Connecting to Monitor Mounting a C-Mount lensOperating Your Camera Connecting to PowerConfiguration of The Menu Setting Up The Menu Camera IDPress SET button If you make a mistake while entering nameBacklight White Balance ControlMotion Detection Lens Selection Tips on Using the Motion Detection FeatureWhen using Auto Iris Lens with Video type Shutter Speed Control FLK1/100 for Ntsc Model,1/120 for PAL ModelAGC Auto Gain Control Sense upSSNRSamsung Super Noise Reduction Special‘Sync.’ mode is fixed to ‘INT’ in DC 12V input power Using Remote Jack / MD Output / D&N Input Setup menu CommandProblem Solution TroubleshootingProblem Specifications PAL SHC-730PMemo
Related manuals
Manual 24 pages 60.29 Kb