Sony DPF-VR100, DPF-XR100 operating instructions 33 GB

\\Miyoshi-win\data1 (k)\+++NouhinMiyoshi+++\DPF-XR100_IM\0825M_4259434111XR100.VR100_IM_GB\070C05.fm Master: Right

010COV.book Page 33 Wednesday, August 25, 2010 12:06 PM

Symptom	Check item	Cause/Solutions
Cannot delete an	• Is the memory card write-	c Use the device you are using to cancel
image.	protected? Or is the write-	write-protection and try deleting again.
	protect switch locked?	c Slide the write-protect switch to the
		enable position.
	• Is this image protected?	c Check the image information from the
		single view mode (page 16).
		c An image with a	mark is set to “Read
		Only”. You cannot delete it on the photo
		frame.
Nothing happens		c Turn off the power then turn it on
even if you operate		(page 12).
the photo frame.	—	c Push the reset switch on the back of the
		photo frame using a long, thin object such
		as a pin, etc. (page 9).
The photo frame	—	c Use maintenance mode to initialize the
does not start.		system of the photo frame (page 26).
Nothing happens	• Is the battery inserted in the	c Replace the battery. (Digital Photo Frame
even if you operate	remote control properly?	Handbook, “Preparing the remote control”
the remote control.		c Insert a battery in the proper orientation.
		(Digital Photo Frame Handbook,
		“Preparing the remote control”)
				Troubleshooting
	• Is there a protective sheet	c Remove the protective sheet (page 10).
		c Point the top end of the remote control
		towards the remote sensor on the photo
	—	frame.
		c Remove any obstruction between the
		remote control and the remote sensor.
	inserted?

33 GB

DPF-XR100/VR100 4-259-440-11(1)