Sharp VL AH 50 H Using the Counter Memory, During playback, press the Menu Button until appears

Camera mode

1 During recording, press the MENU

button until appears.

• If “MEMORY” is not displayed, press the COUNTER button.

2 Perform steps 2 and 3 above.

3 When you are ready to finish recording, press the REC START/STOP button.

4 Set the Power switch to VCR, then perform steps 5 and 6 above.

To cancel Counter Memory mode

Perform step 1 above, and press the MEMORY button. “M” will disappear from the screen.

Note:

• This feature does not work during video search.

Using the Counter Memory

Use the counter memory feature when you want to return to the beginning of a particular scene. The position where the counter was reset (0:00.00) is stored in memory to make it easier to return to that point on the tape.

VCR mode

1 During playback, press the MENU

button untilappears.

0				1 8		0 0
GAMA	COU -	MEM-	R E -		S E -
E F F .	NT E R	ORY	SE T		ARCH

•If “MEMORY” is not displayed, press the COUNTER button.

2 Press the MEMORY button to set the counter to Counter Memory mode.

•“M” will be displayed to the left of the counter.

MEM-

ORY

Memory indicator

			M		0	1 8 3 1
GAMA	COU -	MEM-	R E -				S E -
E F F .	NT E R	ORY		SE T			ARCH

3 Press the RESET button to reset the counter to zero at the beginning of the scene that you want to return to later.

R E -

SE T

			M	0	0 0 0 0
GAMA	COU -	MEM-	R E -			S E -
E F F .	NT E R	ORY		SE T		ARCH

4 Press the MENU button until appears. When you are ready to finish playback, press the STOP button (A).

5 Press the REW button (C).

•The tape will automatically stop when the counter reaches 0:00.00.

			M	0	1 1		2 4
REW	P L A Y	F F	S T OP			S T I L L
			M	0	0 0		0 0
REW	P L A Y	F F	S T OP			S T I L L

Notes:

•The FF button (B) can be used in the same way.

•The tape may stop slightly ahead or behind the point where you reset the counter to “M 0:00.00”.

6 Press the PLAY button (D) to view the desired scene.

Useful Features

40