Toshiba Toshiba Network Camera quick start IR LEDs

Page 12

CAMERA BASE

•Front View

	IR LEDs
Lens	(SR-LED)
Lens
	Light Sensor
	Focus Button
	Lens cover
Mounting	Tilt adjustment
screws	screws
Status LED

•Rear View

Micro SD/

SDHC Card

Slot

Recessed

Reset Button

General I/O

Terminal Block

1.GND

2.Power input (DC 12V)

3.Power input (AC 24V)

4.Power input (AC 24V)

5.Signal GND

6.Digital Input

7.Digital output

DIP switch

Microphone Video Output

NTSC

internal 60Hz

external PAL 50Hz

12

Audio/Video Out (Printed "AV Out")

8. 12V DC Output

10/100BaseT Ethernet Socket

MIC In

(Printed "Audio In")

NOTE

Fix microphone switch to the external, because IK-WR14A doesn't have built-in microphone.

12

Image 12

Contents Model IK-WR14A Introduction FCC USA-INFORMATIONTerms and Trademarks Table of Contents Important Safeguards Damage Requiring Service Replacement PartsSafety Check LightningField Installation Marking Keep the camera installation away from video noise Check the ambient temperature and humidityDo not aim the camera at the sun Do not shoot intense light Setting the Network Camera Environment Administrators personal computerPackage Contents Physical Description Camera Base Dome Cover Cover screws Side Opening CoverIR LEDs Hardware Installation Operating environmentWaterproof Connector Ceiling and Wall mount Page Power over Ethernet PoE Network DeploymentGeneral Connection without PoE Assigning IP Address Retrieving Images Adjusting the Lens To adjust the viewing angleDome cover Adjusting the Zoom and Focus To adjust the zoom factor and focus rangeToshiba America Information SYSTEMS, INC

Related manuals

Manual 20 pages 23.97 Kb