Toshiba Toshiba Network Camera quick start Ceiling and Wall mount

3

o:white/orange stripe O: orange solid

g:white/green stripe B: blue solid

b:white/blue stripe G: green solid

br: white/brown stripe

BR: brown solid

o

O g

B b

G br

BR

1

2

3

4

5

6

7

8

3.You will need an RJ45 crimping tool to attach the Ethernet wires to a connec- tor. When done, connect the cable to the camera’s Ethernet socket .

NOTE

• RJ45 crimping tool and plug are not included.

• Use Category (Cat) 5e or higher cable.

4. Press the Ethernet cable into the routing path at the bottom of

the camera so that the cable will not get in the way when the 4 mounting plate is attached.

Ceiling and Wall mount

Notes:

• The included screws and anchors are used to install the camera to a solid surface. (e.g. concrete) If installing on loose or thin material surfaces , use the appropriate anchors (not included) with the screws.

• Generally point the status LED towards the object. • Install the camera securely.

1.Attach the supplied alignment sticker to the ceiling or wall.

2.Using the circle marks on the sticker, drill four pilot holes (Ø0.19inch×1.02inches(D)

(Ø4.8mm×26mm(D))) symmetrically on each side into the ceiling. Then hammer the four sup- plied plastic anchors into the holes.

3.Through four holes on the mounting plate, insert the supplied screws into the corresponding holes and secure the mounting plate with a screwdriver.

4.Drill a hole (Ø1.0inch(Ø25mm)) in the triangular cutout of mounting plate, and lead the cables through this hole. (A)

5.Align the three mounting holes of the camera with the three studs on the mounting plate and tighten them with a supplied torx wrench securely.

Cable installation

If possible, lead all cables behind the camera body through a wall or ceiling.

If this is not possible, remove the side opening cover with a screwdriver (B), and to route the cables through the side. (Refer to the page 11.)

1	A
	2

5

3

15