Toshiba Toshiba Network Camera When using a PoE-enabled switch, When using a non-PoE switch

Page 14

Power over Ethernet (PoE)

• When using a PoE-enabled switch

The camera is PoE-compliant, allowing transmission of power and data via single LAN cable. See the following illustration to connect the camera to a PoE switch via LAN cable.

Client PC

(not supplied)

PoE switch

(not supplied)

• When using a non-PoE switch

Use a PoE power injector (not supplied) to connect between the camera and a non-PoE switch.

PoE power injector

(not supplied)

non-PoE switch (not supplied)

Client PC

(not supplied)

14

Image 14

Contents Model IK-WD12A Introduction FCC USA-INFORMATIONTerms and Trademarks Table of Contents Important Safeguards Safety Check Damage Requiring ServiceOther trouble. Replacement Parts LightningField Installation Marking Do not aim the camera at the sun Keep the camera installation away from video noiseCheck the ambient temperature and humidity Do not shoot intense lightAdministrators personal computer Items needed for network camera monitoringContents Physical Description Dome CoverMounting the camera to a solid surface Hardware InstallationCable installation Network Deployment General Connection without PoEWhen using a PoE-enabled switch When using a non-PoE switchAssigning IP Address Retrieving Images Adjusting the Lens To adjust the viewing angleTo adjust the zoom factor and focus range Completion Toshiba America Information SYSTEMS, INC

Related manuals

Manual 120 pages 55.36 Kb

Manual 24 pages 23.69 Kb