Introduction |
| Installation |
|
| CONNECTING THE REMOTE CONTROLLER |
❖ Rear |
| |
|
| To control the camera, a remote controller should be connected to. |
1.
2.KEY_E
3.GND
4.DSPSTB
5.DSPSDI
6.DSPSDO
7.DSPSCK
8.FSPE
1.L/L PULSE
2.Alarm_out
3.GND
4.Video out
5.GND
6.V+12V
1. | L/L PULSEulse |
|
|
|
2. | Alarm_outout | 8 | 8 | 8 |
|
| 34 | 34 | 34 |
|
| 9 | 9 | 9 |
3. GND |
|
|
| |
4. | Video out ou |
|
|
|
5. GND |
|
|
| |
6. | V+12V | <CONTROLLER> | ||
oPort for camera’s firmware update. For further details, refer to the below table:
NO | Port Name | Description | |
1 | L/L PULSE | Clock port for | |
2 | Alarm_out | Alarm out port for motion detection. | |
3 | GND | Grounding Port. | |
4 | Video out | This is connected to the Video Input Port of the monitor and it outputs | |
the Video signals. | |||
|
| ||
5 | GND | Grounding Port. |
6V+12VInput port for DC 12 V power.
1.Connect the camera’s video out port to the CONTROLLER’s VIDEO IN.
2.Connect the CONTROLLER’s VIDEO OUT port to a monitor’s video in.
❖You can use the menu as following :
-Press and hold [ENTER]: Moves to the main menu screen.
-Press [ENTER] briefly: Used to confirm the current settings.
-Four Direction Keys: Used to move the cursor up/down or left/right.
14 – High Resolution Compact ATM Camera | 15 |