Samsung L200 manual Connecting to a Power Source, Still image Movie

Connecting to a Power Source

You should use the rechargeable battery SLB-10A supplied with the camera. Be sure to charge the battery before using the camera.

„ SLB-10A rechargeable battery Specification

Model	SLB-10A
Type	Lithium Ion
Capacity	1,050mAh
Voltage	3.7V
Charging time(When the camera is turned off)	Approx. 180 MIN

„Number of images and battery life : Using the SLB-10A

	Still image		Movie
Battery life		Number of images	Recording time
Approx. 140 MIN		Approx. 280 shots	Approx. 130 MIN
	Using the fully charged battery,
	Auto mode, 10M image size
	Fine image quality, Shot to shot
	interval: 30Sec. Changing the		Using the fully charged
	zoom position between the Wide		battery
Conditions	and the Tele after every shot.		640x480 image size
	Using the flash on every second		30fps frame rate
	shot. Using the camera for 5
	minutes and then Powering it off
	for 1 minute.

KThese figures are measured under Samsung’s standard conditions and shooting conditions and may vary depending on the user’s methods.

Important information about battery usage.

xWhen the camera is not used, turn off the camera power.

xPlease remove the battery if the camera will not be used for long periods. Batteries can lose power over time and are prone to leaking if kept inside the camera.

xLow temperatures (below 0°C) can affect the performance of the battery and you may experience reduced battery life.

xBatteries will usually recover at normal temperatures.

xDuring extended use of the camera, the camera body may become warm. This is perfectly normal.

12