Samsung NV24 HD, ECNV24HBBA manual Continuous shot, Metering

Page 37

Continuous shot

You can select the type of shooting and the number of continuous shots.

[SINGLE]

: Take one picture only

AEB

 

 

 

 

[CONTINUOUS] : Images will be taken

 

 

M. CAPTURE

 

 

 

continuously until the shutter

HIGH SPEED

 

 

 

CONTINUOUS

 

 

 

button is released.

 

 

 

SINGLE

 

 

 

The shooting capacity depends

 

 

 

 

 

 

 

 

on the memory.

 

 

 

[HIGH SPEED]

: Continuous shooting is available while pressing and

 

holding the shutter button (About 2 frames per second).

 

The shooting speed may get slower depending on the

 

shooting environment or the number of shots (if taking

 

more then 20 images).

 

 

 

[M. CAPTURE]

: This takes 10 shots per second, when the shutter is

 

pressed and held down. After completing the continuous

 

shooting, images are saved and the images play back on

 

the Rear AMOLED. The maximum number of shots is 30

 

and the image size is fixed as 1024x768.

[AEB]

: Take three pictures in a series using different exposures :

 

standard exposure (0.0EV), Short exposure (-1/2EV) and

 

over exposure (+1/2EV).

 

 

 

※High resolution and picture quality increases file saving time, which increases stand-by time.

※If the [CONTINUOUS], [HIGH SPEED], [M. CAPTURE] or [AEB] sub menu is selected, the flash is switched off automatically.

※It is best to use a tripod for the AEB shooting as the time to save each image file is longer and blurring caused by camera shake may occur.

※When the [M. CAPTURE] menu is selected, you only can select ISO AUTO, 400, 800, 1600, 3200.

※The ACB function is not available when the [HIGH SPEED], [M.CAPTURE] or [AEB] options are enabled.

<<36 >>

Metering

If you cannot obtain suitable exposure conditions, you can change the metering method to take brighter pictures.

[MULTI]

: Exposure will be calculated based on

 

 

 

 

 

 

 

an average of the available light in the

CENTER

 

 

 

image area. However, the calculation

 

 

 

SPOT

 

 

 

will be biased towards the centre of

 

 

 

MULTI

 

 

 

the image area.

 

 

 

 

 

 

 

 

This is suitable for general use.

 

 

 

[SPOT]

: Only the rectangular area in the centre

 

 

 

 

of the AMOLED monitor will be metered for light. This is suitable

 

when you want the subject in the centre correctly exposed,

 

regardless of the back lighting.

 

 

 

[CENTER]

: Exposure will be calculated based on an average of the

 

available light in the image area. However, the calculation will be

 

biased towards the centre of the image area. This is suitable for

 

taking a picture of small objects like flowers or insects.

※If the subject is not the centre of the focus area, do not use the spot metering as this may result in an exposure error. In this circumstance, it is better to use exposure compensation.

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Page Getting to Know your camera InstructionsThank you for buying a Samsung Digital Camera Page Contents Playing back a movie clip Playing back a still imageMovie clip capture function On camera movie trimmingAuto power off Sound VolumePlaying Images OSD setPlayback Requirements System RequirementsRemote control Cradle SCC-NV4HD Hdmi cable Camera case System chartIncluded items Optional itemsRemote control sensor Identification of featuresPower button Front & TopRear Cradle Optional BottomTripod socket TerminalMode icon Self-timer lampCamera Status Lamp SLB-1137D rechargeable battery specification Connecting to a Power SourceConnecting to a Power Source Charging LED of the AC Adapter When the cradle is not usedInsert the battery as shown Inserting the BatteryBattery Indicator Inserting the memory cardInstructions on using the memory card Image Still1280 AboutWhen Using the Camera for the First Time Smart button Setting up the date, time and date type Setting up the languageVertical smart button Smart buttonIcons Amoled monitor indicatorHow to use the Auto mode Starting the recording modeHow to use the Program mode Close the battery chamber coverHow to use the Dual is Dual Image Stabilization mode How to use the Manual modeThings to watch out for using the Dual is mode How to use the Scene mode Night, Portrait scene modeSelect a desired mode by rotating the mode dial What is H.264MPEG4 part10/AVC ? How to use the Movie modeRecording HD High Definition movie clips ButtonUsing Successive Recording Using Photo Style Selector ModeRecording the movie clip without sound You can record the movie clip without soundPressing the shutter button down half way Things to Watch Out for When Taking PicturesPower button Using the camera buttons to set the cameraShutter button OIS Optical Image Stabilization buttonSubject will appear nearer Zoom W / T buttonDigital zoom Tele Wide Zoom Menu Using the Amoled monitor to set the cameraTypes of focus modes and focus ranges Selecting focus typeFocus Type Wide W Tele T Flash When using the Dual IS, ContinuousCafé mode, the flash will not operate Unit mSize Flash mode indicator1280 640 320 Focus Area Center AF Metering Continuous shotSaturation control Image AdjustSharpness ContrastEffect Pictures can be adjusted prior to shootingQuality / Frame rate It can only be set if Is selected on the photoDescription of Self-timer / Remote mode Self-timer / Remote controlRemote control range Replacing battery for the remote controlVoice recording Voice recording / Voice memoWhite balance Using the Custom White BalanceExposure compensation You can select the ISO sensitivity when taking picturesCompensating Exposure ACB Auto Contrast Balance Setting up the shutter speedShutter Speed Aperture ValueScene menu Select the Play mode by pressing Play mode button Starting play modePlaying back a still image Playing back a movie clipOn camera movie trimming Movie clip capture functionPlaying back a recorded voice Playing back a recorded voice memoON/OFF Description IconPlay mode button Using the camera buttons to adjust the cameraYou can play the movie clip and images by remote control Back buttonThumbnail display Thumbnail / Enlargement buttonImage enlargement Maximum enlargement rate in proportion to the image sizePlaying Images Press the Smart button to select a desired play back modeImages for a specific date or all images can be played Photos can beSetting play interval Configure slide show effectsStarting the slide show Images can be displayed continuously at pre-set intervalsDeleting images Protecting imagesThis is used to delete the displayed image Many prints to make Configure number Prints for all picturesPrinters, or at an increasing number of photo labs But are not selectableDpof Print size Setting the Print SizeDpof Index Image Resize Types Rotating an image ResizeStart IMAGE, the existing startup image will be deleted Elegant Colour Filter Special ColourShaded Noise effect Contrast control Brightness control Red eye removalYou can change the brightness of the image Red eye effect can be removed from the captured imagePress the Anynet+ button on the TV remote control How to use the Anynet+CECAnynet+CEC Saturation controlPrint mode Setting up the camera for connection to a printerPictBridge Easy printingReset Printing images Custom modeCustom Set Sub menu Setup menuRecording LowMenu Main menu Sub menu How to select the setup menuOSD set You can adjust the Amoled brightnessDisplay Bright Hdmi SizeStart up image Operation Sound Sound VolumeFile name Shutter soundStart up sound AF soundAuto Focus lamp Self Portrait Quick viewCopy To Card Imprinting the recording dateThere is an option to include Date / Time on still images Formatting a memory Delete AllSub menus No The memory will not be formatted No Image! message will appearLanguage Setting up the Date / Time / Date typeWorld Time Connecting to an external monitor Movie output signal from the camera can be Ntsc or PALInitialisation Selecting Video out typeAuto power off Important notes Extremes in temperature may cause problemsSand can be particularly troublesome to cameras Handling the cameraFile Error Camera MaintenanceDo not attempt to disassemble or modify the camera Card LockedLow Battery Before contacting a service centreDCF Full Error Low LightIncorrect memory card format € Re-format the memory card Images are unclearImage Sensor SpecificationsLens ShutterEffect FlashWhite Balance Voice RecordingWeight Dimensions WxHxDOperating Humidity SoftwareSystem Requirements Software Notes1GB recommended QuickTime Player 7.4 H.264MPEG4.AVC playback RequirementsQuickTime Player 7.4 The movie viewing program About the softwareYou can visit the Samsung web-site through the internet Setting up the application softwareSetting up the application software Connecting the camera to a PC Starting PC modeSelect the USB-Computer menu by using Connect the PC to the camera with the USB CableDownloading stored images Using Removable DiskConnect the camera to your PC with the USB cable CutWindows 98SE Removing the removable diskSetting up the USB Driver for MAC Using the USB Driver for MACTo remove the USB driver, refer to the process shown below Samsung Master Image edit You can edit the still image Image viewer You can view the stored imagesMedia asf file types SaturationFAQ → Plays back using the video player How to playback the H.264MPEG4.AVC movie clipsFCC notice Correct Disposal of This ProductDeclaration of Conformity Correct disposal of batteries in this product Memo
Top Page Image Contents