Samsung ECNV24HBBA, NV24 HD Self-timer / Remote control, Description of Self-timer / Remote mode

Page 40

Self-timer / Remote control

This function is used when the photographer would also like to be in the picture.

- Selecting a self-timer :

 

REMOTE

 

When you press the ‘shutter’ button, the picture

 

 

DOUBLE

will be taken after the specified time has

 

2 SEC

 

 

elapsed and the self-timer function will stay on.

 

10 SEC

 

OFF

- Selecting a remote mode :

 

 

 

 

Pressing the shutter button of a separate

 

 

remote control will allow an interval of 2

 

 

seconds before the image is taken. After taking

 

 

a picture, the remote mode will be maintained.

 

 

But, pressing the Power button will cancel the remote mode.

 

 

Description of Self-timer / Remote mode

Icon

Mode

Description

 

OFF

You can not use the self-timer function.

 

 

 

 

10 SEC

Pressing the shutter button will allow an interval of

 

10 seconds before the image is taken.

 

 

 

2 SEC

Pressing the shutter button will allow an interval of

 

2 seconds before the image is taken.

 

 

 

DOUBLE

A picture will be taken after about 10 seconds and

 

2 seconds later a second picture will be taken.

 

REMOTE

You can take a picture by remote control instead of

 

using the shutter button of the camera.

Remote control range

When you take a picture by using the remote control, refer to the illustrations shown alongside about the remote control range.

[Shutter button on the remote control]

Replacing battery for the remote control

Make sure the + (positive) polarity is toward the top and the - (negative) polarity is toward the bottom while installing battery for the remote control. Replace battery for the remote control in the local service centre.

Use the CR 2025 3V battery.

● When taking a picture using the self-timer, the self-timer lamp works as follows :

10 second self-timer setting :

-The self-timer lamp blinks at 1 second interval for the first 7 seconds.

It blinks at 0.25 second interval for the remaining 3 seconds.

2 second self-timer setting

-The self-timer lamp blinks at 0.25 second interval for 2 seconds.

If you operate the Back button during the self-timer operation, the self-timer function is canceled.

Use a tripod to prevent camera shake.

<<39 >>

Image 40
Contents Page Getting to Know your camera InstructionsThank you for buying a Samsung Digital Camera Page Contents Playing back a still image Playing back a movie clipMovie clip capture function On camera movie trimmingSound Volume Auto power offPlaying Images OSD setSystem Requirements Playback RequirementsSystem chart Remote control Cradle SCC-NV4HD Hdmi cable Camera caseIncluded items Optional itemsIdentification of features Remote control sensorPower button Front & TopRear Bottom Cradle OptionalTripod socket TerminalMode icon Self-timer lampCamera Status Lamp Connecting to a Power Source SLB-1137D rechargeable battery specificationConnecting to a Power Source When the cradle is not used Charging LED of the AC AdapterInserting the Battery Insert the battery as shownBattery Indicator Inserting the memory cardInstructions on using the memory card Still Image1280 AboutWhen Using the Camera for the First Time Smart button Setting up the language Setting up the date, time and date typeVertical smart button Smart buttonAmoled monitor indicator IconsStarting the recording mode How to use the Auto modeHow to use the Program mode Close the battery chamber coverHow to use the Dual is Dual Image Stabilization mode How to use the Manual modeThings to watch out for using the Dual is mode How to use the Scene mode Night, Portrait scene modeSelect a desired mode by rotating the mode dial How to use the Movie mode What is H.264MPEG4 part10/AVC ?Recording HD High Definition movie clips ButtonUsing Photo Style Selector Mode Using Successive RecordingRecording the movie clip without sound You can record the movie clip without soundThings to Watch Out for When Taking Pictures Pressing the shutter button down half wayUsing the camera buttons to set the camera Power buttonShutter button OIS Optical Image Stabilization buttonSubject will appear nearer Zoom W / T buttonDigital zoom Tele Wide Zoom Using the Amoled monitor to set the camera MenuTypes of focus modes and focus ranges Selecting focus typeFocus Type Wide W Tele T When using the Dual IS, Continuous FlashCafé mode, the flash will not operate Unit mSize Flash mode indicator1280 640 320 Focus Area Center AF Continuous shot MeteringImage Adjust Saturation controlSharpness ContrastPictures can be adjusted prior to shooting EffectQuality / Frame rate It can only be set if Is selected on the photoSelf-timer / Remote control Description of Self-timer / Remote modeRemote control range Replacing battery for the remote controlVoice recording / Voice memo Voice recordingUsing the Custom White Balance White balanceExposure compensation You can select the ISO sensitivity when taking picturesCompensating Exposure Setting up the shutter speed ACB Auto Contrast BalanceShutter Speed Aperture ValueScene menu Starting play mode Select the Play mode by pressing Play mode buttonPlaying back a still image Playing back a movie clipMovie clip capture function On camera movie trimmingPlaying back a recorded voice Playing back a recorded voice memoDescription Icon ON/OFFUsing the camera buttons to adjust the camera Play mode buttonYou can play the movie clip and images by remote control Back buttonThumbnail / Enlargement button Thumbnail displayImage enlargement Maximum enlargement rate in proportion to the image sizePress the Smart button to select a desired play back mode Playing ImagesImages for a specific date or all images can be played Photos can beConfigure slide show effects Setting play intervalStarting the slide show Images can be displayed continuously at pre-set intervalsDeleting images Protecting imagesThis is used to delete the displayed image Configure number Prints for all pictures Many prints to makePrinters, or at an increasing number of photo labs But are not selectableDpof Print size Setting the Print SizeDpof Index Rotating an image Resize Image Resize TypesStart IMAGE, the existing startup image will be deleted Elegant Colour Filter Special ColourShaded Noise effect Brightness control Red eye removal Contrast controlYou can change the brightness of the image Red eye effect can be removed from the captured imageHow to use the Anynet+CEC Press the Anynet+ button on the TV remote controlAnynet+CEC Saturation controlSetting up the camera for connection to a printer Print modePictBridge Easy printingReset Printing images Custom modeCustom Set Setup menu Sub menuRecording LowHow to select the setup menu Menu Main menu Sub menuYou can adjust the Amoled brightness OSD setDisplay Bright Hdmi SizeSound Volume Start up image Operation SoundShutter sound File nameStart up sound AF soundSelf Portrait Quick view Auto Focus lampCopy To Card Imprinting the recording dateThere is an option to include Date / Time on still images Delete All Formatting a memorySub menus No The memory will not be formatted No Image! message will appearLanguage Setting up the Date / Time / Date typeWorld Time Movie output signal from the camera can be Ntsc or PAL Connecting to an external monitorInitialisation Selecting Video out typeAuto power off Extremes in temperature may cause problems Important notesSand can be particularly troublesome to cameras Handling the cameraCamera Maintenance File ErrorDo not attempt to disassemble or modify the camera Card LockedBefore contacting a service centre Low BatteryDCF Full Error Low LightImages are unclear Incorrect memory card format € Re-format the memory cardSpecifications Image SensorLens ShutterFlash EffectWhite Balance Voice RecordingDimensions WxHxD WeightOperating Humidity SoftwareSoftware Notes System Requirements1GB recommended QuickTime Player 7.4 H.264MPEG4.AVC playback RequirementsAbout the software QuickTime Player 7.4 The movie viewing programSetting up the application software You can visit the Samsung web-site through the internetSetting up the application software Starting PC mode Connecting the camera to a PCSelect the USB-Computer menu by using Connect the PC to the camera with the USB CableUsing Removable Disk Downloading stored imagesConnect the camera to your PC with the USB cable CutRemoving the removable disk Windows 98SESetting up the USB Driver for MAC Using the USB Driver for MACTo remove the USB driver, refer to the process shown below Samsung Master Image viewer You can view the stored images Image edit You can edit the still imageSaturation Media asf file typesFAQ How to playback the H.264MPEG4.AVC movie clips → Plays back using the video playerFCC notice Correct Disposal of This ProductDeclaration of Conformity Correct disposal of batteries in this product Memo