Nikon SB 11 instruction manual Wide-Flash Adapter SW-3 CD

Page 15

Wide-Flash Adapter SW-3 CD

The angle of illumination of the SB-ll by itself is 56° horizontally and 40° vertically-wide enough for use with a 35mm wideangle lens. When the Wide-Flash Adapter is clipped onto the front of the flash head, it in- creases the illumination to 67° horizontally and 48° ver- tically providing just the right amount of coverage when

a28mm lens is used. With the SW-3 attached, the light output of the speedlight is reduced resulting in a decrease in gUide number from 36 (ASAIISO 100 and meters) to 25. The ASAIISO 25 and feet guide number is reduced from 60 to 42 .

Note: To detach the Wide ·Flosh Adopter SW-3, first rotate the tilting flash head to other than the horizontal position. Then lift up the catch 01 the top of the S W-3 to remove it.

15

Image 15
Contents Nikon Nomenclature Page Contents Foreword Tighten the screws to secure Open the battery chamberClose the battery chamber Attach the bracket @ to Attach the .bracket toSpeedhght Wheel completely Attach the sync cord@ Plug in the sensorRotate the flash head CD To the normal shooting position Nization Set the exposure Calculator dialSet the lens aperture ring to an appropriate Number Set the shooting mode selector Take the picture Controls in Detail Tilting Flash Head CD Controls in DetailWide-Flash Adapter SW-3 CD Exposure Calculator Dial For Automatic OperationExample For Manual Operation At the M Manual Position Sensor Unit SU-2 CDAt the Auto Positions At the S Slave PositionOpen-Flash Button @ Ready-Light @Sync/Multiple Flash Sockets External Power Terminal @Synchronization Chart Sync Cord SellNikon Camera Proper synchronization speed sec TTL Remote Cords SC-12 and SC-23 Sensor Remote Cord SC-13Sync Cord SC-15 RED EYE~-I \ \ Page Optimum Battery Performance Light output control Power sourceDimensions WeightNlko