Nikon SB 11 instruction manual

Page 24

- TIPS ON SPEEDLIGHT CARE ---------

1(;"------,-

\ "",

\ \

To remove dirt or fingerprints, wipe with a dry soft or silicon- treated cloth. Never use thinner, benzine or alcohol, since they might damage the plastic parts. To clean the Wide-Flash Adapter, wash it with soap and water. Never use a brush, as this may damage it.

If you do not plan to use the unit for more than two weeks, remove the batteries to avoid possible damage to the circuitry by battery leakage. If leakage should inad- vertently occur, take the flash unit to your nearest Nikon authorized service facility.

To prevent damage to the flash unit's electronic circuitry, keep the camera away from places where the temperature is likely to go higher than 50°C, such as inside the trunk of a car in the hot summer sun; also do not store the unit in exceptionally damp places. Use the SB-llwithin the range of -lOoCrv + 50°C.

24

Image 24
Contents Nikon Nomenclature Page Contents Foreword Open the battery chamber Tighten the screws to secureClose the battery chamber Attach the bracket @ to Attach the .bracket toSpeedhght Wheel completely Attach the sync cord@ Plug in the sensorRotate the flash head CD To the normal shooting position Nization Set the exposure Calculator dialSet the lens aperture ring to an appropriate Number Set the shooting mode selector Take the picture Controls in Detail Controls in Detail Tilting Flash Head CDWide-Flash Adapter SW-3 CD Exposure Calculator Dial For Automatic OperationExample For Manual Operation Sensor Unit SU-2 CD At the Auto PositionsAt the S Slave Position At the M Manual PositionReady-Light @ Open-Flash Button @External Power Terminal @ Sync/Multiple Flash Sockets Synchronization Chart Sync Cord Sell Nikon Camera Proper synchronization speed sec TTL Remote Cords SC-12 and SC-23 Sensor Remote Cord SC-13Sync Cord SC-15 RED EYE~-I \ \ Page Optimum Battery Performance Power source DimensionsWeight Light output controlNlko