Nikon SB 11 instruction manual Close the battery chamber

Page 7

4. Load the batteries.

Insert eight AA-type penlight batteries following the + and - symbols on the inside of the battery clip.

5. Install the battery clip.

Insert the battery clip into the battery chamber. Make sure the ter- minal end goes in first. Then line up the V-shaped notch on the end of the c li p with the white dot on the rim of the battery chamber . Push the clip until it drops into the fully seated position.

6. Close the battery chamber.

Screw the battery lid back into place.

Image 7

Contents Nikon Nomenclature Page Contents Foreword Tighten the screws to secure Open the battery chamberClose the battery chamber Attach the .bracket to Attach the bracket @ toSpeedhght Wheel completely Plug in the sensor Attach the sync cord@Rotate the flash head CD To the normal shooting position Set the exposure Calculator dial NizationSet the lens aperture ring to an appropriate Number Set the shooting mode selector Take the picture Controls in Detail Tilting Flash Head CD Controls in DetailWide-Flash Adapter SW-3 CD For Automatic Operation Exposure Calculator DialExample For Manual Operation At the M Manual Position Sensor Unit SU-2 CDAt the Auto Positions At the S Slave PositionOpen-Flash Button @ Ready-Light @Sync/Multiple Flash Sockets External Power Terminal @Sync Cord Sell Synchronization ChartNikon Camera Proper synchronization speed sec Sensor Remote Cord SC-13 TTL Remote Cords SC-12 and SC-23Sync Cord SC-15 RED EYE~-I \ \ Page Optimum Battery Performance Light output control Power sourceDimensions WeightNlko