Metz 28 CS-2 instruction manual Displays, Manual partial light output, Flash readiness indication

Page 20

9.5 Manual partial light output

Manual partial light output can only be set in manual flash mode M.

Continue depressing the pre-select key of the flash unit until “P 1/” and the partial light output value flash on the display. While these data are flashing use the “+” or “-” key to set the required partial light output on the flash unit. Partial light output values of P 1/1 (maximum light output) to P 1/16 (minimum manual partial light output) can be set. The setting becomes instantly effective and is automatically stored after 5 s.

After storage the LC display indicates again the f-stop

￿instead of the partial light output.

10. Displays

10.1 Flash readiness indication

The flash readiness indicator on the slave flash unit lights up when the flash capacitor is fully charged to confirm that the slave is ready for firing. The slave will not be triggered if a shot is taken before the flash ready signal is lit.

When flash readiness is established a test flash can be fired with the “TEST” button. In the auto flash mode A and the manual flash mode M, this test flash is based on the adjusted flash parame- ters. In the Metz-Remote Flash Mode, the test flash has a low light output level. In the “EASY” mode a controlled test flash is fired, in conformity with the settings made.

10.2 Correct exposure confirmation

The “o.k.” correct exposure indicator lights up for approx. 3 s when the shot was correctly exposed in the auto flash mode A or EASY mode. When in auto flash mode A this depends on the set flash parameters (see Chapter 9), and in the EASY mode on the selected light control.

This enables you, for example in the automatic flash mode, to establish a suitable aperture by manually triggering a test flash.

Fire a test flash with the manual firing button . If the “o.k.” correct exposure indicator does not light up then set the next smaller f- number, or reduce the distance to the subject, and repeat the test flash.

104

Image 20
Contents Mecablitz 28 CS-2 digital Contents Foreword11.2 Meter-Feet changeover m ft 106 11.3 Safety instructions Loading and replacing the batteries Power supplyPreparations Switching the flash unit on and off Automatic switch-off function / AUTO-OFFFlash coverage and reflector attachments Mounting / Removing the flash unitSlave mode Switch on and shoot in Easy modeTo terminate briefly depress the Mode key Adapting the slave flash unitSlave modes SL Slave mode without preflash suppression SL Settings on the slave flash unitAdapting the flash unit Slave mode with Preflash suppression SLAdapted slave mode SL Settings for camera and flash unit Briefly depress the Mode key to terminateFlash unit setting Cameras where operating mode, ISO and aperture can be setCamera setting Cameras where operating mode, ISO and aperture cannot be set Auto flash mode a Setting procedureFlash modes Avoid exposing the sensor to direct sunlightManual flash mode M Metz-Remote Flash Mode SLEasy Mode Flash parameters Automatic f-stopISO speed Reflector statusFlash exposure correction value EV Displays Manual partial light outputFlash readiness indication Correct exposure confirmationMaximum flash range indication Meter-Feet changeover m ft Automatic switch-off functionSpecial functions Following settings are made Re-establishing the flash unit settingsSetting procedure to adapt flash delay Troubleshooting, remedies and after-sales service ProblemForming the flash capacitor QuestionUnsuccessful troubleshooting Technical data Page Bouton d’essai et témoin de recyclage Manual firing button and flash-ready indicatorTasten für Wertverstellung Regleta giratoria para la cámara Vite camera e stativo Tornillo para cámara y trípode171 172 173 Metz-Werke GmbH & Co KG Postfach 1267 D-90506 Zirndorf