14. Special functions Beep function | 14. Special functions | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Locking
Fig. 28: Switching on the beep function
The beep function can be used to indicate certain flashgun functions acoustical- ly. An acoustic signal (beep) may be selected for the following situations:
•Flash readiness
•Correct exposure
•Incorrect operation (alarm)
An intermittent beep signalling alarm sounds:
•When, after loading a user program, the adjusted and stored operating modes do not coincide.
•When, after calling a user program, a deviating ISO film speed is detected.
•When the flashgun is adjusted to auto mode, but the set values for aperture and ISO film speed will exceed the light output control range. The aperture is auto- matically adjusted to the next permissible
•When the ISO film speed or the aperture are readjusted in the auto mode with the result that the light output control range would be exceeded.
•When the camera transmits a focal length shorter than 24 mm.
•When the
•When the exposure is o.k. but flash readiness has not yet been reached.
Fig. 29: Locking the controls
Switching on the „Beep“ function
Press the |
| button and switch the function on (display | 1 | ) or off (display | 0 | ) | |||
with the + or - button . |
|
|
|
| |||||
Locking the controls (key function) |
|
|
|
|
| ||||
Switch | locks all buttons and switches to prevent inadvertent readjustment | ||||||||
during flash operation. |
|
|
|
|
|
|
| ||
The buttons | /ML | and | as well as the main switch | will not be | |||||
locked. |
|
|
|
|
|
|
|
|
|
Switching on with the controls locked
If you switch the flashgun on with the controls locked, the operating mode indi- cator in the LC display will blink. This is a reminder that you should:
-set the operating mode selector to the operating mode which is blinking (if it is not already there) and
- unlock switch | and lock it again. |
☞Always carry out these two steps, since incorrect exposures may otherwise result (depending on the operating mode).
50 | 51 |