Kodak GE680C user manual Network card TCP/IP address

Page 16

GE680 User Manual

70-0026A-A

oSelect the Internet Protocol (TCP/IP) check box and then select Properties. See Figure 6. Network card TCP/IP address.. Select the Use the following IP address and enter an IP address of 169. 254. x. y, where x and y can be any number. Press the TAB key after entering the IP address and the subnet mask will automatically be entered. The subnet mask is 255. 255. 0. 0. Click OK to save changes. Note that if Windows reports a conflict with the above IP address, simply repeat the above steps and change the last digit of the IP address to a different value.

Figure 6. Network card TCP/IP address.

Prosilica Inc.

14

Image 16

Contents Prosilica November 1Table of Contents Warranty PrecautionsIntroduction Specifications Supported Features BGR24, RGBA24, BGRA24Mechanical MM Deep Plcs TYPGE Series connection diagram ConnectionsItem 1 Gigabit Ethernet Port Item 2 General Purpose I/O PortGPO Item 3 Mini-SMB Trigger InputItem 5 Status LED Item 4 Mini-SMB Sync OutItem 6 Status LED Item 7 Auxiliary Power Port Cleaning the Sensor Cleaning with AirContact Cleaning Identifying DebrisLoosen Locking Ring Adjusting the C-mountImage to Infinity Camera Installation Computer InterfaceGigabit Ethernet Setup for Windows Network card main properties windowNetwork card TCP/IP address Gigabit Ethernet Cabling Power ConnectionOther Cabling Installing GigE Viewer for Testing GigE Viewer application windowSystem Optimization Network card advanced settings Trouble Shooting Driver IssuesCheck the Basics Test the Camera with the Prosilica Viewer