Polaroid 35 manual FCC Notice U.S.A. only, EMI Notice Canada

Page 13

11

FCC Notice (U.S.A. only)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

·Reorient or relocate the receiving antenna of the radio or television.

·increase the separation between the equipment and the receiver.

·Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

·Consult the dealer for help.

Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

EMI Notice (Canada)

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numerique de la classe B respects toutes les exigences du Reglement sur le materiel broullieur du Canada.

Image 13
Contents Page Table of contents Introduction Open the film-holder door 2m Loading film664 665 Plug the Daylab 35 power supply Connecting the power supplySetting the exposure controls Determining the processing time of the filmVIEW-OFF-PRINT switch Correcting prints from color slides Setting the Color-filtration controlsIf you want Add Subtract Orient your slide on the slide carrier Preparing to make a printProcessing the film Exposing the filmFrom the film holder Fogged print light image or no image at all An image blurred. out of focusPrint either too light or too dark An image printed backwardsCurtain-shaped mark or broad streak WarrantyAn oblong in the print20 For information or assistanceEMI Notice Canada FCC Notice U.S.A. onlyHeavy-duty trays IncludesThermometer Print tongsPage