Allied International GX1660C manual Allied Vision Technologies Canada Inc

Page 41

GX1660 User Manual

70-0057A-A

FrameTrigger – Active when an image has been initiated to start. This is a logic trigger internal to the camera, which is initiated by an external trigger or software trigger event.

Exposing – Active for the duration of sensor exposure.

FrameReadout – Active at during frame readout, i.e. the transferring of image data from the CCD to camera memory.

Acquiring – Active during a acquisition stream.

SyncIn1 – Active when there is an external trigger at syncIn1 SyncIn2 – Active when there is an external trigger at syncIn2

Strobe1 – The output signal is controlled according to Strobe1 settings.

NOTE: Refer to camera waveform diagrams for more detailed information.

2 - Settings specific to SyncOut2 (definitions same as above)

3 - Settings specific to SyncOut3 (definitions same as above)

Stats

StatDriverType - There are two main types of drivers currently available for use with Prosilica's cameras: Standard, and Filter. Using the Filter driver will reduce the load on the host CPU. If this value shows "Filter", the filter driver is installed and is being used. If it reports "Standard", then the filter driver is not installed, or is not activated.

StatFilterVersion - Version of the filter driver being used.

StatFrameRate - The current actual frame rate of the camera as received by the driver.

StatFramesCompleted - The number of frames captured since the start of imaging.

StatFramesDropped - The number of frames dropped during transmission since the start of imaging.

NOTE: If everything is configured correctly, this number should be zero. See StreamBytesPerSecond, PacketSize, and refer to the Host Computer Optimizations note.

StatPacketsErroneous – The number of improperly formed packets. If this number is non-zero, it suggests a possible camera hardware failure.

StatPacketsMissed - The number of packets missed since the start of imaging.

NOTE: If everything is configured correctly, this number should remain zero, or at least very low compared to StatPacketsReceived. See StreamBytesPerSecond, PacketSize, and refer to Host Computer Optimizations note.

StatPacketsReceived - The number of packets received by the driver since the start of imaging.

StatPacketsRequested – The number of resend requests since the start of imaging. When an expected packet is not received by the driver, it is recognized as missing and the driver requests the camera to resend it.

StatPacketsResent - The number of packets resent by the camera since the start of imaging.

Allied Vision Technologies (Canada) Inc.

39

Image 41
Contents GX1660 GX1660C Table of Contents Introduction PrecautionsWarranty Specifications BGR24, RGBA24, BGRA24 Supported FeaturesMechanical Connections GX Connection DiagramPIN Function External Power Sync Outputs 1 to GPO Lens Control Port AS Seen from Back Camera Do not Contact Clean Sensor Unless Absolutely Necessary Cleaning the SensorLoosen Locking Ring Adjusting the C-mountNetwork Card Configuration Allied Vision Technologies Canada Inc Allied Vision Technologies Canada Inc Allied Vision Technologies Canada Inc GigE Viewer application window GigE Sample Viewer and Filter DriverIs the camera getting power? Trouble ShootingIpconfig /all screenshot Saving camera setting file Addendum 3V Logic GX IO SchematicCircuit User Trigger Circuit ExampleCommon Iris TV Zoom Lens Focus Unipolar Type TV Zoom Lens ConnectionVideo Iris Connection Trigger Timing Diagram Definitions Triggering during the Readout State Camera Controls Allied Vision Technologies Canada Inc DSP Allied Vision Technologies Canada Inc Gain setting Allied Vision Technologies Canada Inc Allied Vision Technologies Canada Inc Allied Vision Technologies Canada Inc Allied Vision Technologies Canada Inc SyncIn Allied Vision Technologies Canada Inc