Allied International GX1660C manual Allied Vision Technologies Canada Inc

Page 37

GX1660 User Manual

70-0057A-A

WhitebalValueRed – Red gain expressed as a percentage of the camera default setting.

WhitebalValueBlue - Blue gain expressed as a percentage of the camera default setting.

GigE

BandwidthCtrlMode

StreamBytesPerSecond - The default mode of bandwidth control. See the StreamBytesPerSecond control for more information.

SCPD - Stream channel packet delay expressed in timestamp counter units. This mode is not recommended.

Both - Implements a combination of control modes. This mode is not recommended

Ethernet

DeviceEthAddress - The physical MAC address of the camera

HostEthAddress - The physical MAC address of the host network card

IP

DeviceEthAddress - The current IP address of the camera

HostEthAddress - The current IP address of the host network interface.

GvcpRetries - The maximum number of resend requests that the host will attempt when trying to recover a lost packet.

HeartbeatInterval – In milliseconds. The interval at which the API sends a heartbeat command to the camera. Normally this parameter does not require adjustment.

HeartbeatTimeout - In milliseconds. The maximum amount of time the camera will wait for a heartbeat command before timing out.

NOTE: this value may need to be increased when using breakpoints in your API code. Breakpoints stall the API from sending heartbeat commands, which may cause the camera to time out.

Multicast

Multicast mode allows the camera to send image data to all hosts on the same subnet as the camera. The host computer (or SampleViewer application instance) that first enables multicast mode is the master, and controls all camera parameters. All other hosts / instances are the monitors, and can view image data only.

NOTE: Most GigE switches support a maximum PacketSize of 1500 in Multicast mode.

MulticastEnable - Enables Multicast mode. The live view window must be closed to enable this control.

MulticastIPAddress - The multicast IP address can be set using this control.

PacketSize – In Bytes. Determines the Ethernet packet size. Generally speaking this number should be set to as large as the network adaptor will allow. If this number is reduced, then CPU loading will increase. These large packet sizes are called Jumbo Packets/Frames in Ethernet terminology. If your GigE network adaptor

Allied Vision Technologies (Canada) Inc.

35

Image 37
Contents GX1660 GX1660C Table of Contents Warranty PrecautionsIntroduction Specifications BGR24, RGBA24, BGRA24 Supported FeaturesMechanical Connections GX Connection DiagramPIN Function External Power Sync Outputs 1 to GPO Lens Control Port AS Seen from Back Camera Do not Contact Clean Sensor Unless Absolutely Necessary Cleaning the SensorLoosen Locking Ring Adjusting the C-mountNetwork Card Configuration Allied Vision Technologies Canada Inc Allied Vision Technologies Canada Inc Allied Vision Technologies Canada Inc GigE Viewer application window GigE Sample Viewer and Filter DriverIs the camera getting power? Trouble ShootingIpconfig /all screenshot Saving camera setting file Addendum 3V Logic GX IO SchematicCircuit User Trigger Circuit ExampleCommon Iris TV Zoom Lens Focus Unipolar Type TV Zoom Lens ConnectionVideo Iris Connection Trigger Timing Diagram Definitions Triggering during the Readout State Camera Controls Allied Vision Technologies Canada Inc DSP Allied Vision Technologies Canada Inc Gain setting Allied Vision Technologies Canada Inc Allied Vision Technologies Canada Inc Allied Vision Technologies Canada Inc Allied Vision Technologies Canada Inc SyncIn Allied Vision Technologies Canada Inc