Airlink SkyIPCam310 user manual Using the Camera, Web Configuration Utility

5. Using the Camera

You can access and manage the SkyIPCam310 through: 1) a web browser, and 2) the enclosed software IPView Pro. This chapter describes the Web Configuration Utility, and provides the instructions on using the camera with a web browser.

5.1 Web Configuration Utility

The SkyIPCam310 must be configured through its built-in Web-based Configuration. (Extensive knowledge of LAN will be helpful in setting up the SkyIPCam310.)

From the web browser, enter the default IP address 192.168.1.240 in the Address bar and then press [Enter] to access the Welcome screen of the Configuration Utility. The Welcome screen is shown on the next page.

NOTE: The computer’s IP address must correspond with the camera’s IP address in the same segment for the two devices to communicate.

Pre-view area

Welcome Screen of the Configuration Utility

In the Welcome screen, there are three options to choose to set-up and view your SkyIPCam310, including:

zView Image – ActiveX Mode

zView Image – Java Mode

zSystem Administration

20