Adjustment | TOA Electronics C-CV14-2 NTSC specs

7. ADJUSTMENT

1.Switch on the camera power after completing camera connections. Power is supplied to the camera.

2.Normally,set the Shutter Speed switch to "1/60"(NTSC) or "1/50"(PAL) position.

Flickering of the picture may interfere with the view under fluorescent lamp in the area with power frequency of 50 Hz(NTSC) or 1/60 Hz(PAL). In such cases, set the switch to "1/100"(NTSC) or "1/120"(PAL) position, and the image free from flickering can be obtained.

Note

If the Flicker Reduction switch of the Mode Setting switch is set to the ON position, sensitivity is reduced compared to operation in the OFF position. When using the camera in a dark location, or where light flicker is not an annoyance, set the switch to the OFF position.

3.Connect the monitor to the Video Output terminal to permit a picture to be viewed on the monitor.

4.Adjust the camera angle.

Loosen the camera mounting bracket’s lock lever to point the camera to the desired direction, then retighten the lock lever to fix the camera securely.

5.Adjust the angle of view with the Zoom ring and adjust the focus with the Focus ring for the best possible picture reproduction.

Notes

•Since the Iris control (for sensitivity adjustment) is factory-preset to an optimum position for general use, avoid tampering with it in normal conditions. Turning the control unnecessarily could cause reduced picture quality or equipment failure. When the Iris control needs to be readjusted to match a specific subject, first set both the Adjustment switch and the Backlight Compensation switch of the Mode setting switch to the OFF position, then adjust the control to an optimum level. After adjustment, place a hand over the lens for several seconds and then release to check the lens for correct iris operation.

•If the focus is adjusted for a subject under good lighting conditions, the subject may go out of focus when conditions become dark. To avoid this, adjust the lens focus after setting the Adjustment switch of the Mode setting switch to the ON position. Be sure to switch it back to the OFF position after completing lens adjustment.

6.Attach the Lens cover to the camera after completing all necessary adjustments. Note: Refer to p. 7; Lens Cover Attachment and Detachment.

Camera mounting bracket (optional)

Lock lever

Zoom ring		Iris control

Focus ring

Video output terminal

			24V
			12V
			+ -
	IRIS		OFF ON
			OFF ON
			FOUCUS ADJ
			BLC
L		H	SHUTTER
L		H

VIDEO OUT

Mode setting switch

Lens cover