Yazoo/Kees ZEKH48240, ZEKH52240 Adjust Anti-scalp rollers with the mower on a flat level surface

MAINTENANCE

To adjust anti-scalp rollers

Anti-scalp rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desired cutting height in the operating position. Anti-scalp rollers then keep the deck in the proper position to help prevent scalping in most terrain conditions.

IMPORTANT INFORMATION

Adjust Anti-scalp rollers with the mower on a flat level surface.

Anti-scalp roller

1.Adjust the deck to the desired cutting height (see “TO ADJUST DECK CUTTING HEIGHT” in the operation section of this manual).

2.Using a 3/4" wrench and a 9/16" wrench, remove the nut and shoulder bolt from the anti-scalp roller.

3.Lower the anti-scalp roller to the ground, and raise it up to the next highest hole.

4.Replace and tighten the nut and shoulder bolt.

5.Be sure to adjust all of the anti-scalp rollers to the same position.

6.Be sure to readjust the anti-scalp rollers if the cutting height is changed.

IMPORTANT INFORMATION

The anti-scalp rollers must not be used for gauge wheels or the roller and deck may be damaged.

CZ-9

English-49