LUBRICATION
4. Deck outer spindle
Lubricate using a grease gun, one zerk, each side
Use only good quality bearing grease.
5. Engine Oil
Changing the Engine Oil
The engine oil should be changed for the first time after
WARNING!
The engine and the exhaust system, become very hot during operation.
Risk for burns if touched.
Allow engine and exhaust system to cool at least two (2) minutes.
1.Place the machine on a flat surface.
2.Place a container under the engine where the hose from the oil drain valve exits.
3.Remove the dipstick and open the drain valve.
4.Allow the oil to run out into the container.
5.Then close the oil drain valve.
6.Replace the oil filter if necessary.
7.Fill with new engine oil in accordance with Checking the Oil Level.
8.Start the engine. Run it for a few seconds. Stop and
Deck outer spindle
IMPORTANT INFORMATION
Used engine oil is a health hazard and must not be disposed of on the ground or in nature; it should always be disposed of at a workshop or appropriate disposal location.
Avoid skin contact; wash with soap and water in case of spills.
Oil drain valve
