Sirius Satellite Radio SIR-4150 user manual Installation, Connecting to RS-485 Control Terminal

Page 9

Installation

Connecting to Power

The recommended adaptor specification for SIR-4150N/P is DC 12V/4A. Please check the standard power requirement before connecting to power.

When the resistance value of copper wire is at [20°C(68°F)]

Copper wire size(AWG)

#24(0.22mm2)

#22(0.33mm2) #20(0.52mm2)

#18(0.83mm2)

Resistance value(/m)

0.078

0.050

0.030

0.018

Voltage drop(V/m)

0.028

0.018

0.011

0.006

As shown in the table above, voltage decreases as the wire gets longer. Therefore use of an excessively long adaptor output line for connection to the camera may affect the performance of the camera.

Standard voltage for camera operation : DC 12V±10%

There may be some deviation in voltage drop depending on the type of wire and the manufacturer.

Note

Please must be used adaptor that meets the standard requirement.

Please connect the power after installation.

RS-485 communication control

Connecting to RS-485 CONTROL TERMINAL

CONTROL TERMINAL

SPEC

WHITE (TRX+)

RS-485+

BLACK (TRX-)

RS-485-

Using a RS-485 communication, it will be able to control the OSD menu at the SAMSUNG TECHWIN System Controller or DVR.

(1)The case which it controls from the PC

Using a RS-485 converter, It connects to RS-485 CONTROL TERMINAL outside camera and serial cable

EX) SERIAL PORT OF THE PC(COM1) — SERIAL CABLE -- RS-485 CONVERTER

--RS-485 CONTROL TERMINAL

(2)The case which it controls from the DVR or System Controller

It connects the RS-485 CONTROL TERMINAL in the connection terminal of 485 control boards which are connected with the DVR or System Controller.

485 CONTROL BOARD CONNECTION TERMINAL

RS-485 CONTROL TERMINAL

(+)CONNECTION TERMINAL

WHITE (TRX+)

(-)CONNECTION TERMINAL

BLACK (TRX-)

Notes

When you construct external control systems for a camera control, please use to the PELCO-D PROTOCOL.

When you connecting to RS-485 CONTROL TERMINAL, please peel off the outer skin inside the RS-485 CONTROL TERMINAL.

COLOR CCD CAMERA 16 User’s Manual

COLOR CCD CAMERA 17 User’s Manual

Image 9
Contents English SIR-4150 Series Contents Ultra High Sensitivity FeaturesStrong light directly PrecautionsHood Hood adaptor OverviewFocus lever Zoom leverBottom Back Connection Adjust to LensConnecting to RS-485 Control Terminal InstallationOperating Your Camera Menu Setup menuBacklight OFF Lens Adjusting to the brightness levelShutter condition and speed control White Balance controlFLK Backlight Backlight Compensation AGC Auto Gain ControlHIGH/MIDDLE/LOW Sens UP Low illuminance Ssnr Samsung Super Noise reductionSpecial Motion Detection If AGC is OFF, you cant select Auto mode and B/W modeCAM ID COM ADJProblem Solution TroubleshootingSIR-4150N SIR-4150P SpecificationsMemo