LevelOne FCS-5030 user manual Hardware installation, To install in Ethernet

Page 6

Installation

In this manual, "User" refers to whoever has access to the Network Camera, and "Administrator" refers to the person who can configure the Network Camera and grant user access to the camera.

Hardware installation

Please verify that your product package contains all the accessories listed in the foregoing Package Contents. Depending on the user’s application, an Ethernet cable may be needed. The Ethernet cable should meet the specs of UTP Category 5 and not exceed 100 meters in length.

To install in Ethernet

Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet cable plug in the power adapter. If the LED turns out to blink orange-color, go to next paragraph “Software installation”.

This Network Camera provides a general I/O terminal block with one digital input and one digital output device control. The pin definition is as below.

Consult with the dealer of the peripherals for correct installation.

1 SW_NOPEN OUTPUT (Max. 400mA, 12VDC ±5%)

2SW_COMMON OUTPUT (open from SW_OPEN at initial state) (close with SW_OPEN when set DO to ON)

3	DI+	INPUT (Max. 50mA, 12VDC)
4	DI-	INPUT (Initial state of DI is low)

Image 6

Contents LevelOne Page Table of Contents Http Package Content Hardware installation To install in EthernetMake connections Waterproof ProcessSoftware installation How to Use Installation Wizard InstallationDestination Location for Installation Page Using Installation Wizard User InterfacePage Action buttons Function buttons Manual Setup System Setting Change root passwordChange Host Name Adjust date and time Network Setting PPPoE SettingPage LAN Setting Mobile Access Apply to selected device Upgrade Device Information Firmware Information Select FirmwareStart Upgrade Update progress Check Network Settings Initial Access to the Network CameraHow to Use Add Password to prevent Unauthorized AccessAuthentication Installing plug-in Primary user’s capability Main Screen with Camera ViewPage Digital Zoom MP4 Recording SnapshotLocal Settings Page Digital output For Viewing by Mobile Phone Administrator’s capabilityFine-tuning for Best Performance For Best Real-time Video ImagesSomewhere Between Real-time and Clear Images Only Quality Images Will DoProtect Network Camera by passwords Opening accounts for new useBuild a security application Software revision upgrade LAN & PPPoE Basic-NetworkNetwork type Get IP address automatically & Use fixed IP addressPage Video Settings Audio and VideoVideo orientation Audio settings Image Settings Page Privacy Mask Page System User Management Advanced-Network Ddns Two way audio Rtsp StreamingPage IP Filtering Motion detection Event Setup Event Server ServerPage Media Setting Page Recording Page Peripherals System log Maintenance Troubleshooting Reset and restoreURL commands of the Network Camera OverviewStyle convention Get server parameter values General CGI URL syntax and parametersSecurity level Method GET/POSTParameter pair Set server parameter values GroupnameReturn Available parameters on the server 489 ~ NTP serverPage Page Name Value Security Description IntegerGroup dii0~ndi-1 Group doi0~ndo-1Admin Group network Name Value Build-in External TiltZoom Cmos Providerhostna string128 String128 Logerr Logwarning Lognotice Loginfo Logdebug Description Page Audiolineout VideoincodecVideooutcodec AudioincodecTransmissionmode Page Group serveri0~4 Name String40 Enable Priority Drive the digital output Query status of the digital input DonumQuery status of the digital output Account management ResolutionCapture single snapshot ChannelHttp//servername/cgi-bin/admin/syslog.cgi System logsUpgrade firmware IP filteringRtsp SDP Page Specifications NetworkingEMI & Safety Technology License Notice MPEG-4 AAC TechnologyPage Electromagnetic Compatibility EMC LiabilityGNU General Public License GNU General Public License Page Page Page No Warranty