LOREX Technology LW2100 instruction manual Appendix B About Digital Wireless Technology

Page 21

Appendix B: About Digital Wireless Technology

Appendix B: About Digital Wireless Technology

The Digital Wireless signal transmission type used by the Lorex LW2100 is also known as FHSS –Frequency Hopping Spread Spectrum. This type of signal is highly resistant to deliberate jamming as it generates a channel hopping sequence using an algorithm generated by the receiver system.

The 2.4GHz (2.400-2.480Ghz) band is being divided into sections or paths of 2MHz per section, and each second the transmission signal hops hundreds of times in a specified sequence within this frequency range. The overall bandwidth required for frequency hopping is much wider then 2MHz however because transmission occurs only on a small section of this bandwidth at any given time, the signal being transmitted does not suffer from greatly reduced signal degradation and also avoids blocked paths other devices who act as sources of competing signals. The strength of the signal being transmitted is set to be from 13.5-16dBm, which is much higher then the analog transmission signal allowed by authorities around the Globe.

When an image is captured by the camera it is instantly converted from an analog to digital signal and packaged into small packets. With each successful transmission via the 2 MHz paths discussed above, the packets of information containing images are delivered to the receiver and decoded into analog information. The information can then be displayed on devices that are connected to the wireless receiver (RX).

A device pairing process is required to synchronize the transmitter (TX, Camera) and the receiver (RX). This allows the transmitter and receiver to be on the same frequency and use the same algorithm for frequency hopping. This ensures that only the paired transmitter and receiver can maintain communication signal by hopping to the same frequency paths at the exact same time. As a result, the chance that other devices within the same frequency range are on the same frequency, at the same time and in the same order is extremely unlikely. Note that the pairing process is already done at the factory for products that ship within the same packaging. Only when add-on devices are purchased is a pairing process required.

17

Image 21
Contents Digital Wireless Quad View Monitoring System Important Safeguards Before YOU Start Avant DE Commencer Need HELP? Necesita Ayuda Installation Important SafeguardsUse ServiceFCC Notice General PrecautionsFeatures Receiver FeaturesCamera Features Table of Contents Getting Started Wireless CameraConnecting the Camera Wireless ReceiverInstalling the Camera Installation WarningsTo connect the wireless receiver to a TV or VCR Setting up the Wireless ReceiverAuto Viewing ModesQuad split-screen view On-Screen DisplayAdding Cameras Using Auto-ScanSetting Dwell Time Receiver Specifications Appendix a System SpecificationsAppendix B About Digital Wireless Technology Appendix C Strengthening the Range of the Wireless Signal Extending Your Wireless SignalClear Line-of-Sight GHZ Directional Panel Antenna GHZ Omni-Directional Antenna Problem Solution TroubleshootingFAQ Revision Composez LA Ligne D’ASSISTANCE Sans Frais AUS Conommateurs Page See Hear Protect