LOREX Technology LW2100 instruction manual Setting Dwell Time

Page 19

Setting Dwell Time

Setting Dwell Time

You can set the length of time (in seconds) that the receiver displays each channel while in Auto Scan.

To set dwell time:

1.Make sure the Wireless Receiver and cameras are fully connected and powered on.

2.Press and hold the RESOLUTION button and CHANNEL button at the same until the Dwell Time screen appears. Continue holding both buttons.

3.With the CHANNEL button and RESOLUTION button held down, the receiver will automatically cycle the dwell time from 1~20 seconds. The higher the dwell time, the longer each channel remains on-screen during Auto-Scan.

4.Release both buttons to set the desired dwell time.

NOTE: If you repeat this process, the Dwell Time screen will display the last set dwell time.

Figure 7.0 Press and hold the RESOLUTION and CHANNEL buttons at the same time

Figure 7.1 Continue holding both buttons to set the dwell time for Auto Scan

15

Image 19
Contents Digital Wireless Quad View Monitoring System Important Safeguards Before YOU Start Avant DE Commencer Need HELP? Necesita Ayuda Installation Important SafeguardsUse ServiceFCC Notice General PrecautionsReceiver Features FeaturesCamera Features Table of Contents Getting Started Wireless CameraConnecting the Camera Wireless ReceiverInstalling the Camera Installation WarningsTo connect the wireless receiver to a TV or VCR Setting up the Wireless ReceiverAuto Viewing ModesQuad split-screen view On-Screen DisplayAdding Cameras Using Auto-ScanSetting Dwell Time Receiver Specifications Appendix a System SpecificationsAppendix B About Digital Wireless Technology Extending Your Wireless Signal Appendix C Strengthening the Range of the Wireless SignalClear Line-of-Sight GHZ Directional Panel Antenna GHZ Omni-Directional Antenna Problem Solution TroubleshootingFAQ Revision Composez LA Ligne D’ASSISTANCE Sans Frais AUS Conommateurs Page See Hear Protect