LOREX Technology LW1010, LW1012 instruction manual Connecting Camera Power

Page 11

ENG

4.Replace the camera in the desired mounting position. Tighten the side screw to secure the camera to the Stand. Adjust the angle of the camera until the desired view is set.

Connecting Camera Power

The Camera can be powered either by using the provided Power Adaptor, or using a 9v battery and the Battery Adaptor Cable:

POWER ADAPTOR: Connect the Power Adaptor to the Camera.

BATTERY: Connect the battery adaptor cable. Connect a 9 Volt Battery to the adaptor cable

(NOTE: The new 9V Battery should last for approximately 4 hours without the IR LEDs in use).

NOTE: Wireless cameras require a power source (either an electrical outlet or battery power) to operate. If you plan to permanently mount the camera in a location, it is recommended to use the included Camera Power adaptor to prevent interruptions in the image, as the battery adaptor is intended as a temporary power solution.

Power Adaptor: Connect the Power Adaptor to the Female Barrel Power termination on the camera.

Battery: Connect the Camera Battery Adaptor cable to the Female Barrel Power termination on the camera. Connect a battery to the cable.

11

Image 11
Contents Color Wireless Surveillance System Wireless Disclaimer Installation Important SafeguardsUse ServiceFCC Class B Notice General PrecautionsTable of Contents LW1010 / LW1012 FeaturesGetting Started Control Buttons Wireless ReceiverCamera Installation Wireless Receiver InstallationWall Mounting Instructions Installing the CameraConnecting Camera Power Problem Solution TroubleshootingAppendix #2 Camera Specifications Appendix #1 Receiver SpecificationsIt’s all on the web