Clarity E814 manual Cordless handset installation, Connecting the charging base station

cordless handset installation

(Purchased Separately)

Step 1: Connecting the charging base station

•Locate the charging station (A) in close proximity to the corded base station and plug the power supply cord into an electrical outlet.

Step 2: Install rechargeable batteries

•Remove the battery compartment cover (B) by pushing down with thumb and sliding the cover towards the rear of the handset.

•Insert the batteries (C) by aligning the positive and negative end of batteries with the appropriate matching battery compartment contacts. Positive contact (+) to the flat contact of the battery compartment, and negative contact (–) to the spring contact of compartment.

•Replace the battery compartment cover by sliding and pushing upward with thumb until the cover snaps into place.

Step 3: Insert handset on base to charge batteries

•Position the handset on the charging base and charge for 16 hours first time. A beep indicates that the handset is properly placed on the base or charger.

NOTe: Use only NiMH rechargeable batteries. Please refer to the Battery Safety Instructions on page 5 for proper use and disposal of the batteries.

A

C

B

37