using your E814

4.Press <OK/MENU> to confirm the setting; display shows Saved, you will hear a beep; display goes back to the previous screen; press <CLEAr/MUTE> to return to previous menu.

Note: The respective ringer melody will be played during your selection.

Set the Dial Mode

You should normally leave the dialling mode at its default setting of TONE (also called DTMF) unless the phone is connected to an old exchange that only recognizes PULSE dialling.

In Idle:

1.Press <OK/MENU> and <UP/DOWn> to select Settings.

2.Press <OK/MENU> and <UP/DOWn> to select Dial mode.

3.Press <OK/MENU> and <UP/DOWn> to select TONE or PULSE.

4.Press <OK/MENU> to confirm; display briefly shows “Saved”, then it returns to previous menu

Set the Key Tone

The Key Tone is a confirmation beep when you press any key. It is set on by default, but can be turned off, if desired.

In Idle:

1.Press <OK/MENU> and <UP/DOWn> to select Settings.

2.Press <OK/MENU> and <UP/DOWn> to select Key Tones.

3.Press <OK/MENU> and <UP/DOWn> to select On or Off.

4.Press <OK/MENU> to confirm; display briefly shows “Saved”, then it returns to previous menu.

Set the Home Area Code

In Idle:

1.Press <OK/MENU> and <UP/DOWn> to select Settings.

2.Press <OK/MENU> and <UP/DOWn> to select Home area code.

3.Use numeric keypad to enter your local 3-digit area code.

4.Press <OK/MENU> to confirm; display briefly shows “Saved”, then it returns to previous menu.

25

Page 25
Image 25
Clarity E814 manual Set the Dial Mode, Set the Key Tone, Set the Home Area Code