Shure SR105 service manual Specifications

Page 2

SR105 Power Amplifier

SPECIFICATIONS

The following specifications apply to both SR105A and SR105B Power Amplifiers except where noted. The SR105A Power Amplifier provides both direct-coupled speaker output and transformer-coupled, constant-voltage, 70-volt output. The SRlO5B Power Amplifier is equipped for direct-coupled speaker output only.

Amplifier Type . . . . . . .All silicon transistor power amplifier

Power Output . . . . . . ..200 watts rms continuous to 4-ohm load

100 watts rms continuous to

8-ohm load

150 watts rms continuous to

70-volt line (33-ohm load)*

Voltage Gain . . . . . . . . .27 2 2 dB (4-ohm load at 1 kHz) 35 e3.5 dB (33-ohm load at 1 kHz

across 70-volt output)'

Sensitivity . . . . . . . . . . .1.2 volts nominal (full rated output) Frequency Response . . &I.5 dB, 20-20,000 Hz (typical)

*2 dB, 50-15,000 Hz (typical,

70-volt output)"

Input Impedance . . . . .39 kilohms &30%, balanced or unbalanced*

25 kilohms &30%, balanced or unbalanced* *

Total Harmonic

Distortion . . . . . . . .. 2% max. at 1 kHz, 200W (4-ohm load, 28.3 Vrms output)

3% max. at 1 kHz, 150W (33-ohm load, 70.7 Vrms output)*

Hum and Noise . . . . . ..80 dB below rated output (less than

2.8mV at direct-coupled speaker output with Volume Control at 0)

Output Clipping Level. . 28.3 Vrms min. at 1 kHz (4-ohm

load)

Load lmpedance: Direct-Coupled

Speaker Output . . 4 ohms or greater (4 ohms min.)

70-Volt Output* ... . I50 watts max. (33 ohms min.)

Model SR105A only. "Model SR105B only.

Load Regulation: Direct-Coupled

Speaker Output . . Less than 1 dB from no-load to 4- ohm load at 200 watts rms out-

put

70-Volt Output* . . . . Less than 2 dB from no-load to 33- ohm load at 150 watts rms out-

put

Phasing.. . . . . . . . . . . .Pin 3 and phone jack tips of in- puts in phase with speaker out- put phone jack tips, and 28V and 70V terminals

Power Supply . . . . . . . .120 volts, 50/60 Hz ac only. Power consumption: 40 watts max. (20 watts typical) with no signal, 450 watts with 1 kHz signal and 200 watts output; 500 watts maximum

Temperature Range:

Operating . . . . . . . . . -7' to 43OC (20'to 110°F) Storage . . . . . . . . . . .-34' to 74OC (-30' to 165OF)

Dimensions . . . . . . . . ..I78 mm x 483 mm x 270 mm (7 in. H x 19 in. W x 10% in. D)

Weight:

SR105A . . . . . . . . . . .15.66 kg (34 Ib 8 oz)

SR105B . . . . . . . . . . . 12.23 kg (27 Ib) Finish . . . . . . . . . . . . . .Matte black

Installation . . . . . . . . . . Equipped for standard 19" (483

mm)rack mounting; may be op- erated in optional A105A Carry-

ing Case

Certifications ........ Listed by Underwriters' Labora-

tories, Inc.; listed by Canadian Standards Association as certi- fied

Image 2
Contents SR105 Power Amplifier Specifications Iii Page Table of Contents Page SR105 Power Amplifier DescriptionSR105 Power Amplifier Front Panel Operating Instructions General Operating InstructionsThermal Overload Power RequirementsMounting and Ventilation Input ConnectionsSR105 Power Amplifier Block Diagram Output Connections Direct Output only Recommended Wire Gauge VS. AMPLIFIER-TO-SPEAKER Distance AMPLIFIER-TO-SPEAKER Distance MetersVolt Output Output Voltage MeterAdding SR105A Amplifiers in a 70-VOLT System Cascaded Special Operating InstructionsBasic Operating Hints Coil Bridging ConnectionsAdding Headphone Jack to Speaker Connections Service Instructions Printed Circuit Board Removal Small Signal and Predriver Transistors Driver TransistorsDiode Bridge Rectifier Output TransistorsDiodes Checking Transistors and DiodesCOM GRN RED YEL BLKWHT Service Illustrations GNDJI J2 Page TB2 RKC37TB1 XF1RKC9 RKC53IRC CEC-TO Main Circuit Board Parts Location Diagram AC Voltage Measurements TroubleshootingGeneral DC Voltage MeasurementsPage SR105 Power Amplifier Circuit Diagram Page Constant Voltage 70-VOLT Speaker Output Architects Andengineers SpecificationsCondensed Operating Instructions