Send commands [SEL2C5] [+] [+] [+] [+] [+]. After executing that command, send [C5] to get the new status of card 5:
VOLIN1:16
VOLIN2:21
VOLIN3:32
VOLOUT:12
BASS:8
TREBLE:14
LOUDNESS:ON
[SELmGkUi]
This command sets path to adjust the individual volume level for a group of cards. Command Format: [SELmGkUi]
m = Input number (m = 1 to 3)
k = group number (k = # from
+= increases volume. (maximum of 15 levels for audio).
– = decreases volume. (maximum of 15 levels for audio).
Example:
If card 1, 2, and 3 are grouped as group 5 of unit 1, send the [SEL1G5U1]
5. [SLOCnUi]
This command sets path to adjust the output volume level for single card. Command Format: [SLOCnUi]
n = Card ID number (n = slot # from 1 to 19) i = Unit ID number (i = 0 to 9)
+= increases volume. (maximum of 15 levels for audio).
– = decreases volume. (maximum of 15 levels for audio).
Example:
If the status of audio card 5 of unit zero is as follows:
VOLIN1:16
VOLIN2:21
VOLIN3:32
VOLOUT:12
BASS:8
10
TREBLE:14
LOUDNESS:ON
Send commands [SLOC5] [+] [+] [+] [+] [+]. After executing that command, send [C5] to get the new status of card 5:
VOLIN1:16
VOLIN2:21
VOLIN3:32
VOLOUT:17
BASS:8
TREBLE:14
LOUDNESS:ON
6. [VOLmAyCnUi]
This command sets absolute individual volume level for single card. Command Format: [VOLmAyCnUi]
m = Input number (m = 1 to 3)
y = Absolute audio level (y = 1 to 32)
n = Card ID number (n = slot # from 1 to 19) i = Unit ID number (i = 0 to 9)
Example:
If the status of audio card 2 of unit zero is as follows:
VOLIN1:16
VOLIN2:21
VOLIN3:32
VOLOUT:17
BASS:8
TREBLE:14
LOUDNESS:ON
Send commands [VOL1A2CnUi], [VOL2A12CnUi], [VOL3A18CnUi]. After executing the above commands, send [C2] to get the new status of card 2:
VOLIN1:2
VOLIN2:12
VOLIN3:18
VOLOUT:17
BASS:8
TREBLE:14
LOUDNESS:ON
[VOLmAyGkUi]
This command sets absolute individual volume level for a group of cards. Command Format: [VOLmAyGkUi]
m = Input number (m = 1 to 3)
10