Motion Sensor Setup
By connecting the optional motion sensor to the camera’s motion sensor jack, you can enable motion detection alert emails with an attached image. After connecting the sensor as shown, you must configure the camera’s motion detection settings. Refer to Section 3.3 Camera Configuration of the User’s Guide for further information.
Please visit http://www.veo.com/observer/ for information on purchasing the optional motion sensor.
Appendix
F
Mounting the motion sensor to the camera mounting bracket
The motion sensor mounts to the underside of the camera mounting bracket. You need to first attach the metal motion sensor mounting bracket to the backside of the sensor as follows:
1.Remove the sensor front cover by firmly holding the back half of the sensor housing and pulling the front half outward.
2.Locate the two mounting holes on the backside of the sensor housing.
3.Align the two threaded holes in the metal sensor mounting bracket with the holes in the sensor housing.
4.Use the two screws included with the sensor bracket to attach the sensor housing to the bracket by inserting the screws through the housing and threading them into the bracket as shown.
With the
1. Loosen the thumbscrew on the underside of the
2. Align the slot in
3.
4. Rotate the sensor so that it’s facing the same direction as the camera lens.
5. Tighten the thumbscrew (you may need to push hard while threading the thumbscrew through the camera mounting bracket base).
Wiring the sensor to the camera
CAUTION: Disconnect all power to the camera before making any connections.
Page 56 of 65