
Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
Condition | LED color |
|
|
Loading system after power on | Steady green and blink red (once) |
|
|
During booting procedure | Steady green |
|
|
Detecting and setting network | Steady orange (green + red) till IP address |
| is confirmed |
|
|
After network is setup (system up) | Blink green / orange every second and |
| steady red |
|
|
During the upgrade firmware process | Blink green / orange every second and fast |
| blink red |
|
|
Reset and restore
There is a button in the back of the Network Camera. It is used to reset the system or restore the factory default settings. Sometimes resetting the system sets the system back to normal state. If the system problems remain after reset, restore the factory settings and install again.
RESET: Click on the button.
RESTORE:
- 50 -
www.vivotek.com