AGFA DC-1338i operating instructions Declaration of Conformity, FCC Compliance and Advisory

Page 8

Batteries and rechargeable batteries should not be thrown in the trash can. Please return used batteries to the store or take it to where they collets such items. Following this guideline we are helping not to polluting our environment.

Declaration of Conformity

We herewith confirm the following designated product: AGFAPHOTO digital camera DC-1338i has been tested and found to comply with the requirements set up in the council directive on the approximation of the law of members’ states relating to the EMC Directive 2004/108/EC.

For the evaluation regarding to the electromagnet compatibility, the following standards were applied

EN 55022:2006, Class B

EN 55024:1998+A1:2001+A2:2003

IEC 61000-3-2:2005

IEC 61000-4-2:2001

IEC 61000-3-3:2005

IEC 61000-4-3:2006

 

IEC 61000-4.4: 2004

 

IEC 61000-4-5:2005

 

IEC 61000-4-6:2006

 

IEC 61000-4-8:2001

 

IEC 61000-4-11:2004

The device is marked with CE Logo.

 

FCC Compliance and Advisory

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.) this device may not cause harmful interference, and 2.) this device must accept any interference received, including interference that may cause unsatisfactory operation. This equipment has been tested and found to comply with the limits for a Class B peripheral, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

8

Image 8
Contents Precautions DisclaimerParts of the Camera Inserting the Batteries Open the battery cover Close the battery cover Inserting the Memory CardClose the battery cover Insert the batteriesChanging the Mode Set the camera to the REC mode Launch the mode paletteSelect a mode Set the camera to the REC modeUsing the Menus Change the settingOpen the Setup menu Select an itemPress the Menu button to close the menu Using the Stabilizer Press the four-way controlOnline Service / International contact Customer care Service & Repair Hotline EUService & Support Hotline Germany Declaration of Conformity FCC Compliance and Advisory