Setting Wizard
Internet Camera Name | The default camera name is “IPCamera_MJPEG”. It is |
| recommended to enter a meaningful name for the camera. |
IP Address | The wizard will auto setup an available IP Address to the camera. |
| For example: if the IP address of the network is 192.168.2.x, the |
| wizard will search an unused IP Address from 192.168.2.250 to |
| 192.168.2.0 and assign the camera an available IP Address. |
| You are allowed to enter another IP Address to change the |
| setting. |
Subnet Mask | The wizard will auto search the Subnet Mask setting of the |
| network and set the camera in the same Subnet Mask. |
| You can enter another Subnet Mask to change the setting. |
Gateway | The wizard will auto search the Gateway setting of the network |
| and set the camera to use the same Gateway. |
| You can enter another Gateway to change the setting. |
Video Port | It defines the video stream port. The default value is “4321”. |
Cancel | Click “Cancel” to stop wizard setting. |
Finish | Click “Finish” to complete the camera setting. |
|
|
When you finish the camera setting, you can click “Ok” to run the “Camera Viewer” immediately or click “Cancel” to run the “Camera Viewer” later.
23