Rimage 480i Printer
2. Lift the ink cartridge latch to the open position.
Ink cartridge latch
3. If an ink cartridge is already installed, slide the ink cartridge out of the ink cartridge cradle.
4.Remove a new ink cartridge from its packaging and carefully remove the protective tape that covers the ink nozzles.
Important Do not touch the nozzles or the copper contacts on the ink cartridges. If you touch these parts, clogs, ink failure, and poor electrical connections are likely to occur. Do not remove the copper strips.
5.Hold the ink cartridge so that the copper strip is on the bottom and facing toward the printer and slide the ink cartridge into the cradle.
6.Push down on the ink cartridge latch until it snaps closed.
7.Close the Ink Cartridge Access Door. The Ink Cartridge Status light flashes for a few seconds and then stops flashing.
Note: If the ink cartridge is not securely seated in the cradle, the printer will not recognize the ink cartridge. The printer may not reset properly or you may receive an “invalid ink cartridge” message. If this happens:
a.Remove the cartridge and firmly reinsert it.
b.Make sure you are using the appropriate cartridge. Acceptable cartridges are listed in the Ink requirements section on page 1.
c.If the problem persists, replace the cartridge.
8.Using the Aligning the ink cartridges procedure on page 12, align the ink cartridges.
6 | 110761_C |