Operating the Printer
Using Setup Mode to Review Printer Settings
Use the operator panel to review printer settings in Setup mode.
Printer settings are displayed here
Kodak Photo Printer 6800
Power
Ready
Error
3 | 1,2 |
|
|
| |
| Paper |
|
Menu | Advance |
|
Enter | Paper | 5 |
4 | Rewind/Clear | |
|
|
Accessing the Printer Settings
1. | Press Menu to enter Setup Mode. | 4. Press Enter to initiate an action |
2. Press Menu repeatedly to scroll | or accept a change. | |
3. | through the printer settings. | 5. Press Clear to exit Setup Mode. |
Press +/- to scroll through selections. |
| |
Press Menu repeatedly to scroll through the printer settings in the following order.
Printer Setting | Operator Panel | Action Required |
| Display |
|
|
|
|
|
|
|
Printer ready | Ready | None. The printer is on and ready to make prints. |
|
|
|
Making a test print | Test Print Mode | Press enter to make a test print. See “Making a Test Print” on |
|
| page |
|
|
|
Check remaining | Remain = XXX/YYY | None. XXX represents how many remaining prints you can make |
paper status |
| with the current paper roll. YYY represents the total number of |
|
| prints on a paper roll. The counter is reset each time you press |
|
| Paper Rewind. |
|
|
|
Checking the ribbon | DonorRemain = XX[%] | None. XX[%] represents the percentage of the installed ribbon that |
status |
| is available for making prints. |
|
|
|
Checking the printer | Printed = XXXXX | None. XXXXX represents the total number of prints made since the |
total print count |
| printer was manufactured. This counter cannot be reset. |
|
|
|
Checking the printer | Main Firm = | None. The printer control firmware version number is displayed. |
firmware version |
|
|
|
|
|
Checking the image | DSP Firm = | None. The image processing firmware version is displayed. |
processing firmware |
|
|
version |
|
|
|
|
|